Conveyor belt scales | Belt Scales | Precision Mechanical and Electrical

Electrical and Mechanical Technology Co., Ltd. Weifang fine (www.sdjdkj.com) located in Taiping Industrial Park, Shandong Weifang Linqu Jinda Road, Contact: Miss Fu TDG series Dosing chain plate temperature scales, its main features: 1, dedicated to temperature measurement and control of materials. 2, the unique U-shaped skirts chain plate, using 16 Mn 4-5mm thick, by special stamping dies. 3, the transport mechanism uses a single pitch 50.8 scoliosis plate ball chain and sprockets, temperature, wear, no deviation. 4, using the measurement scales Schenck dedicated reducer belt scales, to ensure the long-term stable operation. 5, using precision sensors (tension) suspension weighing. 6, using a digital acquisition module, the effective resolution of up to one million, the acquisition rate of 50 times / sec belt scales, annual drift is less than 50ppm, temperature drift is less than 50ppm. 7, velocity measurement used gear speed or rotary encoder speed. Belt scale belt scale spatial position to meet the following requirements in the spatial location of the installation should: (1) belt scales by feeding section shall coincide with the longitudinal center of the center line under the silo feed stream, the stream should be evenly distributed in the natural accumulation by the belt weigher feed section on both sides of the center line, and press the material flow direction from the subject before and after the material along each segment to maintain a distance of 5cm, material flow stack height does not diffuse material. (2) When using the disc feed mode, the disk is not larger than the discharge gap 200mm, while the disc is not in contact with any part of said body. When the belt weigher not use rewinding equipment should be on-site production of simple closed chute (the chute shall contact occurs during installation and belt scales). Disc feeder streams focused on demand, material flow direction along the belt weigher feeding section is not more than 200mm constant speed belt scales, belt scales on stream at the forefront of the natural accumulation of material from the affected section of the leading edge of each to keep a distance of 5cm (3) when using drag feeder mode, cutting nozzle in contact with the belt conveyor belt shall scales, from the lower end of the belt to retain 5mm or 2 to 3 times the normal diameter of the material away. While the accumulation of material from the belt edge natural edge on both sides of the distance from the Ministry of less than 3cm, natural accumulation of material when using skirts belt incline at the intersection line skirt skirts should be below the upper edge of at least 1cm distance (4) below the belt scale from the main belt height not less than 300mm, and install conveying chute to ensure uniform distribution of material flow in the main belt center. (5) belt scale installation to adapt to the space reserved for the proper maintenance and repair, so that the latter job.