Explosion-proof axial fan manufacturers / proof axial fans PRICE / proof axial fans supply information

Explosion-proof axial fan manufacturers / proof axial fans PRICE / explosion-proof axial fan Supply axial fan is a new fan of the eighties on the basis of BT30-11 improved design, it is compared with BT30-11 fan has obvious advantages: ① structure is more reasonable; ② performance has improved greatly, the total pressure effect was 89.5%; ③ lower noise, noise (sound level than A) reduced 3.6dB (A). Installation Huabo axial fan silencer, the noise can be reduced 30-40dB. Explosion proof motors axial fan blades, hair dryer and other components constituted for conveying flammable non-corrosive gases, ambient temperature must not exceed 60 ℃, widely used in general factories, warehouses, offices, residential heating ventilation or strong heat, may also have a longer interval series exhaust pipe installation, in order to increase pressure in the pipe, remove the motor do free fan. Corrosion axial fan (FT35-11 type), the use of anti-corrosion materials coated with epoxy paint processing, the motor uses special anti-corrosion motor used to transport corrosive gas. Explosion-proof axial fan (BT35-11 type) for gas transport flammable and explosive. Suitable for temperature class T1 ~ T4 environment; impeller machined from aluminum to prevent sparks during operation, the motor with explosion-proof motor. FT35-11 type and BT35-11 type fan performance parameters and dimensions are the same as T35-11-type fan. Fans stand with feet and motor voltage required. Please specify when ordering. Two, BT35-11 series of explosion-proof axial fan Installation Instructions 1. Before installing the fan should be carefully checked for damage deformation, deformation if damaged, to be repaired properly before installation. 2, the installation should pay attention to check the availability of loose coupling portion, the blade and duct clearance should be uniform, not touching. 3, the weight of the pipe connecting the outlet should not be borne by the fan duct, the installation should additional support bracket. 4, the fan must be installed in the concentrator outlet end, and we hope to install protective nets. 5, the fan base must naturally engage the ground plane, can not beat the base to force the join to prevent deformation of the base, the installation should be corrected base, plus horn pieces, keeping the horizontal position, then tighten the bolt. 6. After installation, you must experiment to be functioning properly before allowing the official use. Technical parameters Explosion-proof mark: Eed II BT4 Protection class: IP54 Corrosion grade: WF1 Rated voltage: AC220 / 380 spindle speed: 1450r / min Contact: Room Manager Mobile: 13953413700 Tel: 0534-1395341-3700 Address: Shandong Dezhou City Wu Lu right Tuen County Industrial Park-mail: 1019947457@qq.com Company Website: http: //www.wcdzkt.com welcome your call!