KTV water dispenser factory direct net US source package delivery package is installed

? http://www.chinajmy.com/Products/info/id/92.shtml Model Jmy-2H (new upgraded version) Water tank capacity 18L Products Power 2000W product supply 220V50HZ Water supply water 20L / H; warm water 150L / H Dimensions 500 × 330 × 1240MM out of a warm water faucet of a water filtration stage two cylinder three filters, self-flushing For water 0.05-0.6Mpa, municipal water supply for about 60 people with the number of people drinking NOTE: If all drinking warm water, for drinking the number increased by 60%. If all drinking water, 30% reduction in the number of available drinking, drinking more than the number of the number of decentralized drinking, rather than focus on drinking strength. ① specially prepared food grade 304 stainless steel high efficiency heat exchanger whole, saving 80%. ② automatic control, water is not open, no water out, stop drinking unboiled water, do not need special management. ③ stainless steel design, molded sink, user-friendly design. ④ atmospheric unique design, only drain the pressure, do not waste energy, greatly improving the safety and life of drinking fountains. ⑤ all control lines are 24V DC safe voltage design, greatly improving drinking electrical safety. ⑥ double safety protection, water, warm water after (four PP + sintered carbon + KDF + post carbon) filter and boil temperature sterilization. ⑦ pipeline fully enclosed design, to prevent secondary pollution, drinking water safer. 1. drink warm water, which pour the drink, without waiting, convenient, drinkers satisfaction, improve work efficiency. 2. energy saving, saving 80% than ordinary water boiler. Reduce carbon emissions, in line with the national implementation of environmental policies. 3. safety and health, drinking warm water, more in line with the concept of health. After used in factories, kindergartens, schools, railway stations, airports, hotels, offices and other units to use 20 ℃ water through efficient heat exchanger to absorb water; net US source specializing in the production of large-scale energy-saving drinking fountains, commercial water boilers and other energy-saving equipment to drinking water before entering the water temperature is heating lamps 85 ℃, heated from 85 ℃ to 100 ℃, only heat 15 ℃, boiling drinking ordinary tap water heated from 20 ℃ to 100 ℃ have to heat 80 ℃ so much, so saving water Machine Compared with ordinary water boilers, water dispenser, energy-saving rate: (80-15) ÷ 80 × 100 = 81.25%, measured saving rate> 80% energy saving water dispenser with ordinary water boilers comparison table to work nine hours a day, with an average per people water 1.5 liters, a total of 400 people drinking warm water calculated: according to theoretical calculations and measured: 400 600 heating water to drink every day, only 14 kWh of electricity using clean energy source in the United States and drinking fountains, and use ordinary water boilers required 76 degrees, every day Province 62 kWh to 0.8 yuan / kWh statistics, every year can save 18,000 yuan, according to statistics: drinking warm water ratio and water, saving at least 20 minutes per person per day, to save 4,000 minutes to 400 people a day, the equivalent of four individual workload , according to 4000 yuan / month who calculate wages, to reduce annual salary expenses 192,000 yuan net source of US energy-use water dispensers, 400 people a day with only 14 kWh of electricity consumption, 18,000 yuan a year to save electricity! Improve the efficiency of 180,000 yuan. Popular point in our words, the heat exchanger is set inside a large pipe with six small tube, six small tube inside the water, when the water enters the bassoon, the small tube with six physical cooling effect, the cooling water of 100 degrees to about 35 degrees, while the water temperature through alternating with hot water, the temperature rose to 85 ° water naturally, when the water flow of bile, reheating 15 °, naturally rose to 100 ° water, so our theoretical energy-saving rate 80%. As we all know, when the water is heated, the volume will expand, ordinary electric water heater, common energy-saving water dispenser installed at the water inlet valve relief, but also bear greater pressure tank, because there is no place to relieve pressure. Net US source energy dispenser pressure works as follows: the faucet is designed to tap water and electricity linkage, while electric water boiler installed above the intelligent valve, and designed intelligent electronic control devices. Thus, without water, the solenoid valve is closed, when the electric water boiler heating, the expansion of water and steam discharged from the smart valve to ensure that electric water boiler is not under pressure. When the electric water boiler is not heated, intelligent valve and air Unicom, but also to ensure the electric water boiler is not under pressure. In the case of water, the faucet is opened, water valve linkage the solenoid valve is opened, make the smart valve is closed, so that the pressure under the tap water and warm water flowing uphill. Because the hot water through the heat exchanger into the tank from the bottom of the water boiler is, when the boiling temperature probe detects a temperature below the set temperature, the output command closed inlet valve, and ohmic heating. Thus, even if there is no open faucet water out, avoid drinking unboiled water.