Automotive Brake Parts Test Bench

I. Features of the test bed is used at home and abroad, high-affordable models, auto brake system air compressor, valve, chamber, following the performance test valve, four circuit valve and other devices can be used as vehicle maintenance test equipment, especially for maintenance and testing of city buses. Second, the technical parameters: 1, Power: AC380V 50Hz (three-phase four-wire) 2, motor power: 5.5KW 3, Frequency range: load 0--5000 rev / min; load 0--2000 rev / min (continuously adjustable) 4, the main tank volume: 20LX2 5, sub-tank volume: 2LX4 6, pump subsidiary tank: 10L 7, external gas supply requirements: 0--0.8MPa 8, digital tachometer: 4 display, Range 0--5000 rev / min 9, microcomputer timing device: 6 show, in seconds, after the decimal point 3 namely 000.000 seconds 10, pump rated pressure: 0.5KPa 11, Dimensions: 0.78 m long, 1.6 m wide 1.4 meters high three functions: 1, compressor operation at rated speed, the time to reach a predetermined pressure desired value. 2, the main valve: a main tank through a valve to the inflatable chamber total amount of time (over air time). 3, the gas chamber: the main tank to the inflatable chamber after the set pressure value over time packing. 4, relay valve: the relay valve open and packing. 5, four circuit valve: Four circuit valve opening pressure and holding pressure. Fourth, the installation: Test station must be placed smoothly, legs dangling shall avoid unnecessary vibration. Fifth, the connection: the test stand to the right of the power cord to the AC 380V50Hz (three-phase four-wire) power supply. By "external air supply" mouth. One end of the tube on the selected "external air supply" port and the other end on an external air compressor (air compressor with an oil-water separation devices must "adjust the system pressure" and "System pressure" on the device panel by adjusting the the required pressure, factory-set to 0.6Mpa).