BobrickB-4998 Disabled armrest

Material: grab Bar - 304,18 No. 18-8 (1.2 mm) stainless steel tube with satin finish. 1-1 / 4 (32 mm) outer diameter. End heliarc welded flanges. Backplane - 18-8 3043/16 "(5 mm) thick, satin-polished stainless steel has four screw holes for attachment to the wall Action: Swing up grab bar manually regulated approach or departure, and down to support. horizontal position; once the grab bar is raised to fully upright (vertical) position, the counterweight is designed to prevent dropping down to grab pole position sufficient level meeting in the United States ICC / ANSI A117.1-2003 Accessibility Standards strength: swing. It can support the load from the armrest over 5000 pounds (113 kg), if properly installed, used in accordance with accessibility design specifications (including ADAAG in the US) structural strength. Specifications: Type 304 stainless steel handrail polished handrail should be on the 18th (1.2. mm) thickness and 1-1 / 4 "(32 mm) outside diameter. Backplane should be 3/16 "(5 mm) thick stainless steel, equipped with screw holes for attachment to the wall should be manually raised armrest swing arriving or departing, and lowered to the level of support position; counterweight design grab bars should be prevented from falling down to the full once the grab bar is raised to a horizontal position fully upright (vertical) position handrails shall comply with ICC / ANSI A117.1-2003 accessibility standards in the United States installed: concealed anchor device or provided as a backup provisions or the local building regulations before the end of the wall. Fasten the armrest to secure equipment or support. concealed anchoring devices, and mounting screws are not included Bobrick handrail, you must be specified as an optional accessory.