Inner Heater Model Specifications

Model Specification Inner Mongolia after heating works energized, blowing hot air to the heater in the air, making the air from within the spiral heating tube and the outer uniform by the heat generated after the electric wire is energized and the cold air through the heat exchange, in order to use the outlet air temperature rise. The outlet of K-type thermocouple promptly detected air temperature feedback to the temperature controller, the instrument according to the set temperature monitoring of the actual temperature of the work, and pass the information back to the solid state relay and thus controls the heater is working. Meanwhile, fans can take advantage of the damper (converter, throttle) adjust the air volume blowing air, thus, achieve operating temperature, air volume regulation. In addition, the hot air also on the fan inlet, the motor is set up circuit and over-temperature protection circuit is provided for the total Jicha loved switch, to further improve the protection of the equipment. Beijing Toshihiro Genesis is a production and sales services as one of the manufacturers of the Beijing Office, the company's main heater, electric heater, industrial electric heating heaters, hot air, electric fans, industrial electric heaters, heating oil project fan, patio heaters, umbrella heaters, electric heaters workshop, building site electric fans, electric heating plant, fuel Heaters, electric fan, gas heaters, industrial hot air; but also to the company's official website (electrical engineering Fan heaters http://www.01051265034.com), and other products. Selection may be interested in a wide variety of available contact us, Liu welcome your call 010-51265034 13366708682 Inner heater model specification cleanup drive after a period of hot air, the surface layer of foreign matter and dust, if not cleaned up, affecting heat dissipation. Blower motor after a long run, to deal with motor maintenance and replacement, this operation must be carried out by professionals to judge and maintenance, can not dismantle the motor, which is likely to cause a short circuit and the motor does not turn, the light burning fuse, causing serious burn harness, on fire. Motor ventilation tube can not be removed, after removing easily cause the motor to overheat, burn. Variable resistor to reduce the motor speed change gear, an electric fan, such as long-term use of the plant first, second gear, easy to blow resistance, affecting normal use, found that this problem should be replaced. After prolonged use of the operating system, control cable easy to aging deformation, so that manipulation is not flexible or not in place, do not rigidly to move, to avoid damage to components. This issue should be found to the service station to determine, and repair and replacement depending on the circumstances. Heaters ventilation ducts is No. 1 and 2 hose, due to prolonged use at high temperatures, very easy to aging cracks, identify problems and should be replaced, in order to avoid leaks, causing the water temperature is too high, the engine cylinder head deformation . In other hose application leased vehicle matching hose, hose inferior corrosion intolerance.