Edam revolving door troubleshooting display device

Self-diagnostic display solutions manufacturers have different programs, the following is only one vendor self-diagnostic display apparatus as an example. Above the rotating door wings automatic revolving door there is a fault indicator, according to the fault light A, B, C, D, E, F to analyze different variations of the fault. 1) When the A light is on, then show the inside and outside the revolving door of the emergency stop button is activated, causing the revolving door can not be run clockwise twist unlock button, you can troubleshoot. 2) When the B light, infrared pinch sensor can be checked whether a foreign object is detected by the sensor, but also check column rubber pinch sensor (Note: The above two sensors on both sides have to check) 3) When the F lights, infrared collision on the radio function is activated, when the revolving door is not rotating operation. This failure should check with infrared sensors on both sides if there is not blocked, or because the door has been caused by changes in both infrared radiation sensor can not accurately transmitting and receiving. 4) When the functional intermediate revolving doors sliding doors (including the three functions), if this time the function switch is set to enter, to the position, sliding doors can be opened, but does not close, then the fault light D, F will be lit, you can check whether the push and pull with infrared sensors to accurately transmit and receive, when sliding door is closed D, F and so will go out. 5) When the fault light flashes three beats, then show the utility power is not supplied, the revolving door will automatically find the location of sliding doors, sliding doors at this time to perform the function.