Plastic bottles Vision Inspection System

Bottle appearance quality requirements 1. bottle surface smooth, flat, no defects, no bubbles, does not allow any distortion or obvious scratches, no clean parting line projection, bottle end formation, no boss, no gaps, no Burr and heap of plastic; inside and outside 2. Product clean and free of insects / dust / hair / glass / iron / feed wire and other impurities, no odor, no strong smell of raw materials; 3. labeling area allows ≤0.5mm black spots, non- Labeling area ≤0.5mm black spots no more than three. Test items defect detection precision finish inspection (detection rate of 5 bottles / sec, with a CCD) 1- 0.2mm 2- black dot bottle integrity, ovality 0.2mm 3- bottle bottle burr 0.2mm 4- lack of material or protrusion 0.2mm 5- bottle inner diameter (A) ± 0.2mm 6- crest diameter ± 0.2mm bottle detection (detection rate of 5 bottles / sec, with 3 CCD) 1- black dots 0.2mm 2- impurities, contaminants 0.2mm 3- visible flaw, pitting 0.2mm 4- scratches, burn marks, bubbles 0.2mm (minimum contrast: 15 gray) 5- 6- neck deformation 1.5% higher (H2) ± 0.15 mm