Yun Feng plastic mesh trays custom map grid tray

Second, organize, establishment of the National Association of Pallet recycling plastic. Currently, the Americas and Europe have been set up plastic pallets Recycling Association, in an Asian plastic pallets Recycling Association also Japan, Singapore, Malaysia, South Korea, the Philippines, Indonesia, Thailand, Taiwan and Hong Kong and other eight countries and regions to participate. And to participate in the recovery of these organizations are mainly plastic tray raw materials and products manufacturers, in order to develop their own industries, for their own and the public interest, we must be prepared to recycling their products. Without which, there was no alternative. Correct use of plastic trays should be done with the appropriate code on the packaging mix tying a plastic tray and wrap, easy to use mechanical handling and transportation, to meet the handling, transportation and storage requirements. In order to make plastic pallets can be safely used for a long time, we hope the following requirements according to the proper use of plastic pallets: 1 plastic tray to avoid suffering from sun exposure, in order to avoid aging and shorten life. 2. prohibited goods thrown from a high place in the plastic tray. Reasonably determine the manner of goods stacked in the tray. Goods placed evenly, do not focus stacking, offset stacking. Carrying heavy trays should be placed on a flat surface or a surface. 3. prohibited the plastic tray from a height into the falling, avoid violent impact caused the tray broken, crack. 4. When a forklift or manual hydraulic car operations, fork pallet fork prick holes to the outside as much as possible by foot, fork prick should be fully inserted into the inner tray, after a smooth lift the tray before conversion angle. Pallet fork prick can not hit the side of the tray to avoid crushing, crack. 5. tray on the shelf, shelf-type trays must be used, according to the carrying capacity of the shelf structure, depending on the use of non-overloading. Third: vacuum forming method. Vacuum molding production of plastic pallets are also single-sided and double-sided two. Single-sided plastic tray used for small motors (such as vacuum cleaner motors, electric power tools, etc.) as well as cable tray and other packaging, transportation, faster development, and dedicated mainly. Double-sided plastic tray are assembled, divided into two forms: the upper half piece extruded length, fixed width plastic sheet, lower halves of the large vacuum products; the upper and lower halves are large vacuum forming products. The production of molding requires large vacuum forming equipment, lower equipment costs, tooling costs are lower, but the product uneven thickness.