Locomotive teach you charcoal equipment safety tips

Locomotive teach you charcoal equipment safety tips should establish any products in safety first, charcoal is no exception, production safety has now become the key development of many enterprises, an enterprise can not guarantee safety if workers, So even if the production of even the best equipment futile, so that you want to prepare the ground charcoal development is a must. The carbonized charcoal stove in the carbonization process will produce wood tar and smoke, which contains a lot of carbon monoxide, long-term inhalation can damage the body. So charring environment to take ventilated so that carbon monoxide can be gathered in a timely manner to disperse. At the same time collecting the wood tar and wood vinegar to take protective measures to prevent the liquid irritate the skin. Mechanism of charcoal in the production of charcoal, there are some issues that need to be mastered, is charcoal in the production process will produce on the environment and harmful substances, to reduce risk by rational scientific methods and measures to protect effect. Straw shredder ten security tips: (1) straw shredder should be fixed on the ground, can be fixed with cement. Such as frequent changes in the workplace, grinder and an electric motor to be installed in the angle formed by the machine base. (2) After the straw mill installation should check in place to check whether the installation of enough firm. The motor shaft and the shaft is parallel to the mill, and to check the belt tightness is appropriate. (3) Before straw mill starts to rotate the rotor by hand to check whether flexible work properly, whether the collision phenomenon within the housing, the direction of rotation of the rotor is correct, grinder motors and lubrication is good and so on. (4) stalk shredders do not often replace the pulley to prevent speed is too high or too low. (5) straw mill should start idle 2-3 minutes, no abnormal phenomenon feeding after work. (6) should be uniform straw feed mill, if found to have noises, the bearing and the body temperature is too high or outward paste and so on, should immediately stop inspection, troubleshooting. (7) Before straw mill staff should carefully check material, to prevent the metal, stones and other hard objects into the crushing chamber to cause the accident. (8) When feeding, the staff should stand straw mill side, bounce out of the debris to avoid being injured. When crushed long stems can not grasp the hand tight to prevent the hand was brought. (9) stalk shredders before stopping stop feeding, stand inside the material excluded clean, then cut off the power shutdown. After the shutdown to be cleaned, and maintenance. (10) stalk shredders 300 hours after the operation, to be cleaning bearings, replace oil; when installed oil to fill the gap bearing 1/3 as well, up to a maximum of 1/2. When downtime, remove the belt. Wuhan locomotive Technology Co., Ltd. Contact: Raymond Tel: 13554140363 Contact QQ: 2895199211 Postal: 420040 Website: http: //www.986186.com Fax: 83375590 Address: Wuhan East Lake Jinshan Road 1304 (Gimhae Industry Park) 027-83247888 (registered fixed number) Company registration number: 420112000057566