What mechanism charcoal production process is the primary mechanism charcoal

 What is the use of charcoal mechanism charcoal production is the first step? There is no doubt that the drying. Drying is the production of charcoal in the first process, water is qualified to produce high-quality raw material charcoal premise. Raw material is too dry can cause extrusion molding rod longitudinal cracks appear, serious and even lead to forming rod fire. This time without the need for a uniform mixed with dry ingredients. The raw water is too high generally makes forming rod horizontal cracks appear, accompanied by lower hopper back to the gas, machine "blasting" and so on. Such materials are required to re-drying, experienced manufacturers will try to avoid duplication of drying, in addition to cost considerations outside the more important is the safety factor. With respect to the molding and carbonization, the drying is less technical content of a process, but has a lot of security risks in the actual production, we have to raise safety awareness. Most Tanchang uses a hot air dryer duct, the advantages of this dryer is direct heating, drying speed, installation can be folded to save space. The principle is to let the wet raw in the pipeline and high-temperature air mixing walking, finally get to meet the requirements of the moisture content of raw materials through the separator. A qualified dryer at least the following components: a fuel stove, cutting rolls, gear motor, several sections containing insulation pipes and elbows, fans and separators. Dryer volume of raw materials also have certain requirements, general requirements for particle diameter is less than 8mm. But not too small, otherwise it is easy to burn material in the pipe, causing the dryer, "blasting." Usually we procuring raw water content of between 25% --- 50%, through good moisture content of dried and drying of raw material can be reduced to about 18%, but still not meet the requirements. Many articles in the ideal moisture content of the raw material was set at between 5% --- 13%. But it never for raw water content was measured after drying in the actual production. Because that is very troublesome, and a lag in time. Because the dryer for drying the intensity is not uniform and stable raw material, fuel is added each time you open the door, because the cold air to enter, will rapidly reduce the temperature of the pipe, and add ingredients in the whole drying process is very frequent ( for at least 10 minutes). So the best way is by sight and feel qualified to judge whether its water content. General appearance of the raw material was burnt yellow, seem to have the feeling of weeping to explain its moisture content is acceptable, further verification method is to use the clutch a raw, hard clenched, then let go, to see if the material can be natural spread evenly. The above said is the usual test methods. In fact, the water content of the final decision whether the raw material is qualified molding machine. Just from the extrusion molding machine qualified stick, so that the water content of raw materials to meet the requirements. The key lies in the raw material drying oven temperature control, require workers to be able to promptly adjust the oven temperature depending on the appearance of the material presented. An experienced worker can be judged based on the sound is too high temperature inside the pipe, the pipe material before the first combustion reduce oven temperature to prevent the dryer, "blasting." Dryer ideal fuel flame length, flame bituminous coal. The flame length is largely affected the drying effect. Ideal is the case: the initial stage of the raw material into the pipe together with the flame pumping power of the fan at high speed walk some distance together, the raw material of most of the water is separated out in this distance. Many coal flame is not up to such a request, such as Datong coal. Moreover flame fuels is also important, flame fuel would reduce the number of our door switch, thus ensuring uniformity of drying. Coal in the market both long and flame resistant, flame seems difficult to sell, we usually consider the former should focus on. Wuhan Science and Technology Co., locomotive for many years to research and production mechanism charcoal equipment, mechanism mechanism charcoal, charcoal machine, toner machine, because the focus, so professional; Because professional, lead. Manufacturers Address: Wuhan East Lake Avenue 1304 Jinshan Contact: Raymond 13554140363