Drake planetary reducer | planetary reducer | Niu Geer

Planetary gear installation Precautions: a note before the installation: 1. the unit before using the mounting shaft for cleaning. Check whether the mounting shaft and bumps, dirt, if there should be completely clean. 2. Reducer temperature is 0 ~ 40 ℃. 3. Check with the gear coupling holes (or axis) with the size meets the requirements, tolerance hole should be H7 (shaft tolerance to H6). 4. Blockage before using it at the highest level to put an exhaust plugs ensure expel gas reducer running. II. Reducer installation 1. Reducer can be installed in a flat, shock absorption, and the torsion of the support structure. 2. Under no circumstances use a hammer to belt pulleys, couplings, pinions or sprocket knock on the output shaft, which can damage the bearings and shaft. III. 1. reducer use and installation and maintenance, inspection is flexible. A formal request must be load test using Kunishige planetary gear under normal operating circumstances, gradually loading operation. 2. Reducer shall not exceed the rated load use. 3. Before using the gear and work should check the oil level is normal, the machine at the factory filled with oil, lubricants name: load industrial gear oil GB5903-86220. Planetary Transmission Equipment Co., Ltd., Dongguan Niu Geer to share with an introduction to planetary gear planetary gear reducer getting started planet stainless steel for applications requiring high torque volume ratio (the value at 2-100 Tyrone planetary reducer, it depends on the ratio size), high torsional stiffness and low backlash precision motion control applications, etc., depending on the application. Planetary gear reduction ratio and torque increase by the same factor, as well as the speed is reduced by the same factor, so that the corresponding motor to maintain high efficiency operation. For greater stability, it also reduces the load on the motor equivalent inertia. In short planetary reducer, planetary gear allows the machine manufacturers to build smaller, more economical motion control device. Single-stage planetary gear reducer gear ratio available between 3: between 1: 1-10. The gear ratio can not be higher than 10: 1 is because the size of the pinion can not be further reduced. Gear ratio can not be less than 3: 1, otherwise the pinion gear and almost the same outer dimensions, there is no space to lay out a planetary gear. In 4: 1-8: 1 gear ratio provides the best planetary gear pinion and size, improve performance and extend life. Greater than 10: 1 gear ratio by increasing the second-stage planet gear is obtained, but generally increases the length and cost of the reducer. Crowning gear means to increase torque and less noise and modify gear tooth profile can be optimized gear. It also enhances load distribution Kam Friends flank planet reducer, which reduces the surface pitting may lead to high stress areas. Helical gear contact ratio increases, the performance of the planetary gear can be improved. Contact ratio refers to the gear at any given time engagement. Typical contact ratio spur gears is 1.5, and the contact bevel gear ratio can be doubled to 3.3. By increasing the contact ratio helical gears available: spur gear type planetary gear compared torque increased by more than 30-50% increase in the degree of load sharing, thus extending the life of smooth and quiet operation. The above pictures, the content is for reference only, detailed questions, please call us or on our official website for. . Drake planetary reducer | planetary reducer | 纽格尔 provided by the Dongguan City 纽格尔 Planetary Transmission Equipment Co.. City 纽格尔 Planetary Transmission Equipment Co., Ltd. (www.cn-newgear.com/)(www.cn-newgear.com) strong, credible, in Dongguan, Guangdong reducer, gearbox industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Niu Geer and you work into the brilliant, for a better future!