Drying equipment _ _ phosphorus extraordinary achievements tonemaps drying equipment

Flash dryer fluidized section below the high temperature zone, because the flow of the material section inside the particles maintain a certain moisture material will not overheat, and then dried particles instantly from the high temperature zone, so the spin flash drying apparatus is very heat-sensitive materials apply. After a stream of drying section, the material is broken into various particle sizes of different dried spherical and irregularly shaped particles, in the rotating air buoyancy and radial centrifugal force, not the dried granules to the wall motion, and because of its a large segment of the sedimentation rate and falling reflux repeat fluidized drying; smaller particles up into the drying section. Flash dryer is tangent into the bottom of the hot air dryer to form a powerful rotating wind driven stirrer. Material from the screw feeder into the dryer, the strong role of high-speed rotating impeller, the material by the impact, the role of friction and shearing force is dispersed, the bulk materials will soon be smashed full contact with the hot air, heated and dried . Dried material is carried into the air dust collection system, collection and disposal, environmental compliance dust content "50mg / m3 of exhaust fan vented from the lead, complete the drying process. Changzhou Yihong Drying Equipment Co., Ltd. is one of China environmental protection equipment manufacturers drying, active in a dry environment manufacturing sector. We are willing to share advanced technology, extensive project experience and work practices in line with international health, safety and environmental standards to help users in a dry, sustainable development and environmental protection fields. One of the structural characteristics of flash dryer: hot air at the entrance to set the conical bottom cooling jacket. Hot start contact with the material, the temperature is very high, generally close to the hot air temperature, much higher than the temperature of the bed, the operation will inevitably lead to a small part of the bonding material in the vicinity of the annulus, the residence time is too long, resulting in material deterioration, and even melting, in order to avoid this phenomenon, additional local jacket, can be reduced where the wall temperature to operate smoothly.