Sell ??SZG series Twin Cone Rotary Vacuum Dryer use characteristics

SZG double cone rotary vacuum dryer host double cone tank, the tank in a vacuum state, the jacket can pass into the steam or hot water tank is heated, the heat transfer through the double over the liner to the wet material, wet material moisture vaporization, low-speed motor driven rotary body, the material continuously from top to bottom, inside and outside the flip, replace the heating surface, while water vapor through the vacuum pump is pumped continuously through the exhaust pipe to accelerate the rate of drying, and ultimately achieve uniform drying purposes. Drug management practices in line with GMP requirements. About double cone dryer is set mix - dry in one of the new dryer. Condenser, vacuum pump and dryer facilities, consisting of vacuum drying device. (If no solvent is recovered, the condenser can not) advanced design of this machine, a simple internal structure, easy to clean material discharge all, easy to operate, can reduce labor intensity and improve the working environment. Simultaneously rotating the container itself due to the material, but also rotating wall of the plot is not material, so heat transfer coefficient is high, drying rate, not only save energy, but also uniform drying and have good quality. Drying can be widely used in pharmaceutical, chemical, food, materials, dyes and other industries. In line with "GMP" requirements. Works double cone drier has double cone rotating tank, the tank in a vacuum state, to the jacket into the steam or hot water heating, heat through the tank wall in contact with the wet material. After evaporation of water vapor wet material absorbs heat out through vacuum exhaust pipe is pumped. Since the tank body in a vacuum, and the rotating of tank division continues to make things up and down, inside and outside the flip, so speed up the drying rate of materials, increase drying efficiency, to achieve uniform drying purposes. Characteristics of fast-drying, usually only a few seconds to a few seconds, with a instant dry characteristics. Drying process temperature drops relatively low, especially suitable for drying heat-sensitive materials, to keep the material color, smell and taste. To prevent drying tower have a sticky wall phenomenon, this device is provided with a special structure, effectively put an end to the phenomenon of sticking to the wall of the product. Unique wind supply system finished with the hot dry wet air in the system time to avoid the possibility of drying or agglomeration of the finished absorbent boiling point of the material the solution is reduced under vacuum, the evaporator heat transfer driving force increases for a certain amount of heat transfer amount can be saved evaporator heat transfer area; the heat source for operation of evaporation may be low pressure steam or boiling hot steam; less heat loss in the evaporator can be disinfected before drying, drying process without any impurities It was mixed, in line with GMP requirements; the use of a condenser, which can effectively recycle materials in a solvent.