Manufacturers supply steel bridge colored waterproof finish

This product alkyd resin, pigments, fillers and additives made of one-component self-dry finish, with better equipment decorative and anti-corrosion properties. Key Features:? A certain gloss, color retention. ? Has good water resistance and salt water. ? Has good adhesion and mechanical properties. ? Good construction performance, and a variety of supporting the use of a primer can also be used alone. Uses: used in steel, tanks, vehicles, pipes surface coating. Color and appearance: colored, plain basic parameters: the proportion: 1. 25kg / L dry film thickness: 50Um wet film thickness: 100um Theoretical amount: 125 9 / mz Flash point: 29 ℃ Drying time: (25 ℃) table dry ≤4h Hard work ≤24h Suggested painting number: Suggested painting two. Front-matching paint: alkyd primer iron red, red lead steel rust, phenolic primer, epoxy primer and so on. Surface treatment:? Primed surface must be dry, except for the net all the oil, debris, no moisture condensation on film. ? Oxide steel sandblasted to Sa2.5 level. ? And you can match the old film: In addition to the net all the oil debris. Substrate temperature: substrate temperature above the dew point 3 ℃. Coating Application:? Mixing: The product-component cans, must stir evenly when using available X-6 alkyd thinner to adjust the viscosity. ? Airless spray: Dilute the amount of 0 to 5% (by weight paint) 0.2 ~ 0.4 mm diameter nozzle discharge pressure 15 ~ 20 MPa (about 150 ~ 200kg / cm2) air spray:? Diluting O ~ 10% (with The paint weight) Nozzle diameter 1.5 ~ 2 Omm discharge pressure of 0.3 ~ 0.4 MPa (about 3 ~ 4kg / cm2) Roller / Brush:? Dilute the amount of 0 to 5% (by weight paint) Cleaner:? X -6 alkyd diluent (flash point 29 ℃) Note:? This product is only by professional applicators in industrial situations in accordance with the instructions in this manual and on the container. ? Application and use of this product all work must be carried out according to various national health, safety and environmental standards and regulations related. ? If there is doubt about the suitability of this product, please consult the details of our technical service department. Packaging: 18. 5L barrel 18kg storage and transportation: 1. This product is at a temperature of 25 ℃ effective storage period for a period of 12 months, extended by the inspection qualification can still be used. 2. The product should be stored ventilated, dry, to prevent direct sunlight and away from heat sources. 3. When this product transportation, should prevent rain, sunlight, and should meet the requirements of the transport sector.