Langer MICRO-80 car battery tester battery resistance tester

MICRO-80 tester simple instructions MICRO-80 battery tester, using the world's most advanced conductance testing technology, you can easily, quickly and accurately measure vehicle starter batteries actual cold cranking amps, the health of the battery itself, conducive to the maintenance personnel to quickly and accurately determine the fault location of the car, to facilitate quick repairs cars. 1, you can test all cars starting lead-acid batteries, including ordinary lead-acid batteries, AGM flat battery, AGM wound batteries, gel batteries and so on. 2, can detect a bad cell battery. 3, with reverse polarity protection, reverse the clip will not damage the tester, nor will car and battery have any adverse effects. 4. The loss of electricity can be directly tested battery charged without first re-test. 5, the test criteria included the vast majority of the world's common battery standards such as CCA, BCI, CA, MCA, JIS, DIN, IEC, EN, SAE, GB. Product Description: 1, one year warranty and lifetime maintenance. 2. Application: 12V lead-acid starter batteries. 3, scope of work: 100-800CCA 4, working temperature: -18 ℃ to 50 ℃. 5. Special test clip: twin conductor Kelvin folder. 6, Case Material: acid ABS plastic. 7, the measuring cell range: 30AH-100AH ??8, measuring voltage range: 6-30V steps: 1, the tester red and black clamps to the tested battery, the red positive black negative, the tester display will show the boot screen, Press OK to continue down (Note: test the battery voltage is lower than 6.0V or less can not be properly tested). 2. The tester prompts, navigate to:? Enter the selection criteria: refers to the battery factory labeling standard, just above or in front of the battery can be seen that the selection criteria can be marked on the battery, such as CCA, BCI, DIN and so on. ? Rated Capacity choice: refers to the battery factory starting current standard, just above or in front of the battery can be seen, such as 300A. ? Press the OK button to start the test. On the internal resistance, for the same cell, the smaller the resistance, the better health status (except for short), can be used as the inner resistance of the battery performance of a certain status criteria reference. Tip: For deep loss of electricity batteries (such as vehicles for a long time on hold, the battery is not charged in time; lights, forget to close the door so that the battery can not start serious loss of electric vehicles, etc.), the actual testing process, it may prompt "Replace Battery" For such batteries to the user to consult battery manufacturers, charging methods provided by the manufacturer to charge reduction, and then tested. Process equipment operating in the customer service center of any problems, please contact Chengdu Langer Technology Co., Ltd. Service Department: 86-28-85272353 Technical support: 13,708,091,072 Langer Company Website: http: //www.lancol.com