Metallographic sample cutting machine (50 × 60 × 80mm) and low noise waterproof motor QG-3A

Host Introduction: metallographic sample cutting machine (50 × 60 × 80mm) and low noise waterproof motor QG-3A Details: Product Name: QG-3A metallographic sample cutting machine Description: This machine is used to cut the general gold phase, petrographic sample material, machine equipped with cooling channels and switch when cutting can pass into the coolant configured to dissipate heat generated during cutting, to avoid overheating and burn tissue samples. The machine is easy to use, safe and reliable, it is one of the essential laboratory sample preparation equipment. Wheel bearing spindle mounted on the rocker arm in the v-belt drive and gain momentum for the abrasive cutting of feed movement, cutting feed rate of speed, depending on the speed of the swing arm manually. Above the sample stage of work is quick clamping mechanism, lever can move up and down arbitrarily, clamp, easy to use and flexible, hollow struts through the coolant, the bottom jaw clamps the work, there is a "V" groove for clip tight sample was. Table with a transparent plexiglass shield, observed for protective use when cutting the body and out of waterways and coolant switch, coolant flow size can be adjusted or turned off according to cutting needs. Cooling water tank is designed for storage purposes coolant, coolant configured, it can be recycled. Be sure to use the cooling liquid coolant slip is better configured. Never use tap water as coolant in general. Cutting rock sample material, ceramics, etc., you are only allowed to cut with a diamond grinding wheel cutting. (Diamond grinding wheel to be special order). The main parameters: Maximum cutting width: 60mm Maximum cutting height: 80mm Maximum cutting surface diameter: Φ50mm Grinding wheel size: 250 × 2.0 × 32mm Motor: y90L-2 2.2kw Dimensions: 580 × 560 × 680mm Weight: 150kg