Hubei miniature self-resetting displacement sensor Price

SKRD innerspring miniature self-recovery displacement sensor series, just put the probe in contact with the measured object can be, effective stroke 5mm ~ 25mm, the accuracy of 0.2% ~ 0.1% FS. Shell surface, anodizing, corrosion resistant; built-in conductive plastic measuring unit, no temperature drift, long life; with automatic electrical grounding function. Sealing rating of IP67, have a direct outlet and five-pin plug connector out two options, especially for small installation space for the occasion; top putter no installation, no alignment, pushing angle 90 ± 3 °, allow pushing extreme sports speed of 5m / s, special size can be customized. 1, conductive plastic principle, imports substrate brushes; 2. Measurement path: 5 ~ 125mm; 10 ~ 125mm optional external spring return; 3, small size, space-saving installation: 18 * 18mm; 4, linear accuracy: 0.1 %; 5, the service life: more than 30 million times; 6, optional 4 ~ 20mA; 0 ~ 5; 0 ~ 10V standard signal output (external signal converter box) linear displacement transducer (How to use and how to install one, select linear displacement sensor specifications to be left margin, generally on the basis of the actual travel on the election freshman specifications can be. Second, while paying attention to, 1250mm specifications of the following optional STC rod linear displacement sensors, larger than this stroke specifications, or not After facilitate adjustment of the occasion, should use STF slider Third structure, linear displacement sensor installation should be left at both ends of the balance evenly, do not lock before fixation screws undetermined extreme position can be adjusted stroke OK electronic locking screw fixation foot four, rod-type linear displacement sensor) to pull the ball universal head allows radius neutral bias, of course, the shorter 1mm specifications, recommended deviation smaller. Fifth, after a fixed linear displacement sensor, the lever (STC / STM series are applicable) retracted, universal cylindrical body ball head should be a gap of four radial orientation. Otherwise, adjust the universal head mounting position or adjust the position near the protruding end of the mounting bracket. Six, when the lever is pulled out, if not great, you should adjust the mounting bracket near the plug end of the line. It can be used as an adjunct to review the way. Seven, pull the ball universal head mounting rod and rod allows an angle of ± inclined 12o. However, if the installation misalignment and tilt at the same time are large deviations will affect the linear displacement sensor Linear displacement sensor stability and service life. It should be further adjusted. Eight slider to adjust the linear displacement sensors can reduce the workload of the neutral, but the auxiliary extensions can not be canceled, otherwise, there will be a result of faulty neutral due to the stability and service life, even immediately resulting linear displacement sensor failure. Nine, everything is adjusted, tighten the mounting screws, efforts should be made to ground resistance of less than 1Ω appropriate. 200Ω with a multimeter measure linear displacement sensor gear screw capping resistance between the mounting bracket. Ten, or with a four-wire shielded cable wiring, linear displacement transducer end of the line should be connected to ground, while the fourth side or shielded cable grounded at the electrical control box end.