WMK-A type of dust control instrument controller pulsed electromagnetic pulse valve controller parameter setting spring ..

Pulse controller parameters under the control of the state, if the control device is a power-saving mode, the digital display output from the next "pulse" of the countdown, with the control device indicates lower output side terminal can be monitored at the top of each output point output situation. If the controller display mode is 0, the boot or the stop button operation within 30 seconds, the controller display with mode 1. Once more than 30 seconds, the display only the first three of the decimal point flashes once per second, to enter the power-saving mode. Standby: control after instrument power on. If not the boot and conditions (start signal is switched off), the system will enter standby mode, four digital tube will show "--------." Operating status: power control device to meet the conditions after entering the power running state, the digital display time countdown, the LED displays the status of each output point. POST Status: COM disconnect controller output terminal (very important), press the "Add" button and turn on the power controller, the controller enters the POST state that all outputs are output, digital displays "7777", the other state belong to abnormal control device can easily determine its own fault. Manual inspection mode: In normal operation control device, press the "Add" button, the system enters the manual maintenance state, then press the "Manual" button, the output from all the way back to the beginning of the shift, until re-press " Add "button to exit the manual mode. Botou City Chunhui Environmental Protection Equipment Co. http://www.chinachhb.com/ Contact: Han Tong Tel: 15343174995