Supply Japan Hioki 3390 power analyzer

3390 power analyzer to directly measure the inverter output, the latest analysis techniques to measure motor function (corresponding to an electrical angle measuring, vector control) high-speed harmonic analysis (50 ms data update rate) Inverter interference analysis (FFT function) through clamp sensor Easily the best accuracy of measuring power inverter ± 0.16% (when used in conjunction with 9709) LAN, USB, and CF card and other interfaces ※ 3390-10 hosts can not be measured separately. Please buy different current sensors and voltage line according to measurement purposes. 3390 power analyzer basic parameters of the measuring line of single-phase two-wire, single-phase three-wire, three-phase three-wire, three-phase four-wire, voltage 4ch, current 4ch, channel-isolated voltage measurements (U), current (I), voltage / current peak (Upk / Ipk), active power (P), reactive power (Q), apparent power (S), power factor (λ), phase angle (φ), frequency (f), the cumulative current (Ih ), cumulative power (WP), the efficiency (η), the voltage / current ripple rate (Urf / Irf) interference measurements (FFT algorithm processing): voltage / RMS harmonic spectrum measuring current (RMS value, content of the phase angle The total distortion, disequilibrium factor) Additional features (optional 9791 or 9793 installed on the host): torque, speed, frequency, slip, or the engine output harmonic measurement inputs: 4 channels, synchronization frequency range: 0.5 Hz to 5kHz, harmonic analysis times: Maximum number of measurement channels within interference 100: 1 channel (select 1 from CH1 to CH4 channel), the maximum analysis frequency: 100k / 50k / 20k / 10k / 5k / 2kHz measuring scale voltage range: 15/30/60/150/300/600 / 1500V Current Range: When using the rated sensor 20A of ... * 400m / * 800m / 2/4/8 / 20A (* When using the optional 9277) When using 200A When the rated sensor ... 4/8/20/40/80 / 200A When using sensor 50A rated ... 1/2/5/10/20 / 50A When using 500A rated sensor .. 10 / 20/50/100/200 / 500A depending on the range of voltage and current combinations (power range: 6.0000W to 2.2500MW) Frequency Range: 0.5Hz to 5kHz basic accuracy (45Hz ~ 66Hz) voltage:. ± 0.05% rdg ± 0.05 % fs Current: ± 0.05% rdg ± 0.05% fs + current sensor accuracy of active power:.. ± 0.05% rdg ± 0.05% fs + current sensor accuracy of synchronization frequency range of 0.5Hz to 5kHz frequency DC, 0.5Hz to 150kHz data Update rate 50ms (measuring harmonics, depending on when the synchronization frequency is less than 45Hz) display refresh rate 200ms (internal update rate data from independent, waveform, FFT according to the picture may be) Data save interval off, 50m / 100m / 200m / 500m second, 1/5/10/15 / 30sec, 1/5/10/15/30/60 分钟 external interfaces LAN, USB (communication / storage), RS-232C, CF card, the synchronization control power supply 100 to 240V AC, . 50 / 60Hz, 140VA max volume weight 340mm wide × 170mm high × 157mm thick, 4.8kg accessory manual × 1, Measurement Guide × 1, Power cord × 1, USB cable × 1, D - Sub connector × 1 (only Equipment 9792 or 9793), the Color tag × 2