SL30T-2A-type non-standard models bearing heater operating procedures

SL30T-2A-type non-standard models bearing heater operating procedures 1, according to the inner diameter of the bearing, select the appropriate yoke (see Table 2), the chains over bearing yokes placed to host the core end face should coincide ping. 2, in the heating process, with the point of the bearing inner ring side temperature measuring plane temperature. When the temperature rise to meet the requirements, saw time counting, stop heating, remove the yoke, to remove the bearing assembly. 3, the same size bearings continuous heating, the function selector switch to timed position, set the heating time, when the bearing is heated to the set time automatically shut off the power. 4, after the work is completed, the function selector switch to the stop position, cutting position SL30T-2A-type bearing heater parameters: Rated Capacity: 8KVA voltage: 380V column height: 200 column spacing: 200 vertical heating range: 40-250 level heating range: 180-450