Rotating resistance level switch / level switch

YLSR-10S (ZXK-Z) series resistance rotary level switch Instructions Technical parameters Power supply: 220VAC / 110VAC / 24VAC / 24VDC selectable 50 / 60Hz; contact capacity: prefix = st1 ns = "; urn: schemas-microsoft -com: office: smarttags "; 5A 250VACSPDT; Power consumption: 1.5W; Operating temperature: -10 ~ 80 ℃ (high temperature max200 ℃); thread or flange connection (depending on requirements); Principle of operation of motor driven rotary blade When the measured medium up to the blade position, blade by the dielectric barrier stops to output open by the relevant control mechanism (on) or off (off) the contact signal; when the media fall leave leaves under the action of the spring, blades continue to rotate back into place position change detection medium. Installation should be installed away from the blanking opening, so as not to damage the blade material directly impact and, if necessary, install protective shield over the blade to protect the blade; when the mounting hole size smaller than the size of the blade can be removed first leaves the barrel fixed wall junction box parts and then with a cotter pin the blade is fixed firmly; to avoid outdoor environment rain seep into the terminal box, when horizontally mounted cable entry port to be vertically downward; check the supply voltage and the voltage of the selected products are the same, reference corresponding to each cable to connect the terminal block wiring diagram based on the identity; control line load is not overload use (less Contact capacity use). Note: Please note the connection cable, do not take the wrong, to avoid danger! Precautions to ensure hermetic junction box; regularly check the connection of the components are secure.