Beijing marble adhesive, Beijing marble adhesive manufacturers, Beijing marble adhesive ..

Marble Binder Contact: 13701126040 Liu Xuan I. Product Overview: marble adhesive is a kind of cement as a gelling agent, adding polymer and inorganic powder surety agent, binder and made new Stone adhesive can be applied to a thin layer of adhesive tiles. Implementation of standards JC / T547-2005 GB 6566-2001 Second, the product description: This product is formulated from high quality cement, fillers, synthetic polymers and selected additives such as a combination, 28% by weight of the water feed powder, stir 5min namely It may be used. Third, to product characteristics: 1. High bond strength. High bond strength is about 2 to 3 times the pure cement. 2. Good workability. This product has good water retention, workability, choke crashworthiness, time can be adjusted in Dhaka about 20 minutes. 3. The cost savings. As the thin layer of adhesive bonding powder belongs, can greatly reduce the amount of cost savings. 4. Good durability. This product has a certain flexibility and because it is a thin layer of adhesive, enhanced ability to resist deformation, so it has good durability. Fourth, the purpose and scope: This binder can be widely used stone mortar on the concrete walls, floors and a variety of wall surface of the adhesive tiles. Fifth, the main technical indicators: Testing items rubbing ordinary type tensile strength MPa ≥0.5 1.0 Water original drawing strength MPa ≥0.5 1.0 heat aging pullout strength MPa ≥0.5 1.0 freezing capacity drawing strength MPa ≥0.5 1.0 airing 20min pullout strength ≥0.5 0.5 slip, mm - 0.5 Six construction process: 1) Primary treatment: The base should be smooth, firm, free from dust and oil, etc., available at a slightly uneven adhesive smooth. 2) for: water consumption is 26% -28% by weight of dry powder, depending on the desired consistency and adjust the water construction environment, the powder has been installed into the bucket of clean water, stir with a mixer, then put it aside 3 minutes, then stir to use, add water binder used up within four hours. 3) Paving tiles: Use a trowel to spread the adhesive tuned to the grassroots level surface, wipe the area once the binder should pay attention to the construction time, usually 20 minutes, smoothing after wiping with teeth child to sort out. The tiles on the beat after combing the adhesive, tile location within 15 minutes of time can be adjusted. Paving tiles must be left seam. VII Note: 1) Construction of the temperature should be above 5 ℃, Avoid painting when it rains. 2) deep exterior wall tiles paving the bottom left seam of not less than half of the tile thickness. 3) The product transport and storage should pay attention to water and moisture, can be stored under dry conditions for about six months. Eight, packaging and storage: 1, the product is woven bags attached endometrium, 50 kg / bag 2, placed in storage on pallets off the ground to avoid rain soaked, ensure ventilation, dry, avoid direct sunlight