Imported German Lanxess antistatic agents MersolatH95

Model: Mersolat H95 Usage: plastic antistatic agents Category: antistatic agent H95 Specifications: Flake purposes Use: General Plastics, engineering plastics, masterbatch with the brand German Lanxess Packing: 20 kg / PE bags CAS: 86443 -82-5 Introduction ??? Mersolat H95 appearance of a white sheet, due to the special production process H95 no chlorine ions. ?? Storage, use H95 should pay special attention to the product is strongly hygroscopic. H95 is an anionic surfactant; it is a secondary alkyl sulfonic acid derivative of a compound of specific structure; average carbon chain length of C15; average molecular weight of 330, an active matter content of 95%;? Has the Due H95 its excellent antistatic properties, emulsification dispersion, electrolyte resistance and wettability been successfully used in plastics used as an antistatic agent has a higher cost. ? As we all know, in the antistatic agent results depend essentially on the molecular structure, molecular structure determines the important performance antistatic agents such as polar and migration. H95 molecules in the long carbon chain provides a migration of polar plastics, while its polar groups provides a hygroscopic, ie it must be combined to form a conductive film of moisture. Ionic character of the polar group led H95 surface film of moisture combined with high conductivity. In addition to the chemical composition of antistatic agents, processing methods, and ambient temperature will affect the speed and antistatic agents acting effect. Plastic glass transition temperature also affects the antistatic effect. For those polymers glass transition temperature well above room temperature, the product life cycle in the antistatic agent and does not continuous migration. ?? H95 is particularly suitable for use as the plastic of the antistatic agent in the polymer that can not be directly added to the case, since it is easily soluble in hot water of 50-60 ℃, it may be an aqueous solution (commonly 40% in the form of an aqueous solution) is sprayed or dipped in the product surface. It is generally added in an amount of 0.1 to 2.0. H95 in polystyrene application? Normally produced by adding 1.5-2% of H95 machining polystyrene, but must pay attention to make clear polystyrene atomization concentration above 0.3%. H95 at ABS ABS application process can be added to 1.5-2.5% of H95 to obtain an antistatic effect. H95 H95 Application in the PE also suitable as polyolefins, particularly PE antistatic agent. It can also improve the flow of melt. In this case the addition amount of 1-2% H95 with a high glass transition polymers described above such as PVC, PS, ABS different in PE antistatic agent can continue to migrate to the surface in a long time, and therefore obtain a long-term anti- static effect. ? Food Law situation? H95 German and American food laws. The highest amount in hard and soft PVC in 3% (by weight), in PS 2.5% and 1.5% in PE, and so on. ? ?? Package installed? 20 kg PE bags, white flakes savings deposit ?? ??? Drying room? Because H95 hygroscopic, storage should be taken to avoid tidal influence, unused containers should be sealed.