Lubricant for cylinder lubrication maintenance management

1, should pay attention to oil the oil level, observe the pumping of each pipeline. If an individual no oil pipeline, it should be clear to ensure that grease into the cylinder. Note the amount of oil to be appropriate. The long-term work cylinder wear large, should be appropriate to increase the fuel injection. In order to determine the adequacy of fuel injection, cylinder walls can be touched by hand after stopping, if oily feeling, then the fuel injection is appropriate. 2, a sulfur diesel fuel at low speeds easy to generate sulfuric acid, parking, application transfer machine diesel engine again respond transfer, while moving the hand pump oiler to ensure that there is adequate oil film cylinder wall. 3, to maintain normal exhaust temperatures should not exceed 400 ℃. This is because the surface of the cylinder sleeve and piston ring due to gas heating and temperature, resulting in the destruction of the lubricant film. In addition to the fuel injection, etc., exhaust gas temperature also increases with load increased. In general, diesel power every 10% increase in exhaust gas temperature increased by about 20 ℃ -25 ℃, it should ensure that the diesel engine at normal load operation. 4, can not be blended with the experiment on the use of different varieties of cylinder oil, because they contained additives are often not the same, when blended with use, the chemical reaction can occur between the different additives, lubricants all bad. If such grease into the surface of the cylinder, it will lead to serious accidents. For example, a round due to mix the two cylinders, resulting in seven cylinders all seizures, caused great losses to the safe transport and state property.