Carbon Carbon goose goose sale ball machine ball press machine Silver Base

For silver-based carbon pressure ball machine quality products, quality service is only carried out, it is not completed. "Your Carbon pressure the ball machine, silver-based motive" of the service concept is deeply rooted in the hearts of silver-based people, but also will create the next miracle is carbon pressure ball machine market. Carbon pressure the ball machine molding method using pressurized vibration, the vibration platform start and stop at zero amplitude, to avoid start-up and shutdown process of resonance. During vibration of small amplitude can be achieved feeding a pre-vibration, tap large amplitude vibration process 60-90 seconds to complete, the device can produce different specifications of the anode electrode, with high efficiency, reliable, stable operation and other characteristics, adapt continuously requirements of mass production. High density and various carbon monoliths down evenly, neat appearance, angular groove, the overall defect-free, long service life. Carbon pressure the ball machine is dedicated carbon carbon plant equipment, raw ingredients is reasonable, according to the different sizes of the required materials were metered into the mold, pressurized shock to match the specifications of the equipment. Carbon pressure the ball machine equipment with new automatic program operation, the formation of an automated production line. For the carbon industry has laid a solid foundation. Carbon pressure the ball machine is directly on the raw material after crushing machine production, without adding water. Such as: aluminum powder, activated alumina, lime, etc., which aims to reduce dust, control capacity, return use, improve the transport properties such as production design. Well off the ball for carbonaceous pressure ball machine: Carbon pressure should be checked before first ball machine electrical power ministries is normal. Check the two rolls of the die hole being whether such misalignment, open gear cover, loosen the adjustment screw on the disc six passive gear, reverse rotation driven roller so that the two roller die hole with the post, tighten the screws as well. Work roll gap should be maintained between 0.4-0.7mm, if too much is too small, loose passive roller bearings together and drawing, to be adjusted, after a good tune, tighten the screws and drawing. Secondly Carbon pressure the ball machine after the start of production of the finished product, check whether the twin-roll working surface with such an error occurs, the shroud can be removed in the large gear, loose passive roller gear outer screw to adjust. Finally, strong pressure ball machine pressed by the belt process, spread reducer, reducer through coupling, and then transmitted to the drive shaft by a split gear, ensure that the two roller synchronization (constant reverse) material storage silo by metering device evenly into the molding hopper, the unit material forming pressure from small and large, in the line connecting the centers of the roll forming pressure reaches a maximum, the material through the line, the pressure rapidly decreases forming the material into the ball off state , well off the ball.