Heavy media Jig / sawtooth Jig price / barite beneficiation jig

Product Overview: sawtooth Jig is one of the modern re-election equipment, due to its processing power, a wide range of sorting size, simple operation and maintenance, as crude-election or selection is widely used for sorting gold, tin, titanium, hematite, iron ore, coal and other minerals, in particular, has been widely used in manganese ore, barite ore dressing areas. The traditional jig mostly circumference eccentric drive, which pulsating jig mostly sinusoidal curve, due to the rising movement of the diaphragm, decrease the water flow rate and time is basically the same, therefore, is not conducive to the jig bed loose and mineral particles by the proportion of stratification, thus affecting the sorting and recovery ratio of the device. Sawtooth Jig jig bed is based on the theory of hierarchical rule, in a traditional jig on the basis of the development and improvement of an energy-saving equipment re-election, their pulsating jig jagged curve, so that the water rises faster than the decline water: the rise time is short, long fall time; to overcome the sine curve rising pulsating jig produced the same time decrease the water flow and the role of defects and enhance the loose of the bed to ease the suction effect, making minerals heavy mineral grains are fully settlement, greatly improve equipment sorting and recovery than ability. Jig with sine wave contrast increased: Sn 3.01%, W 5.5%, Pb 1.63%, Zn 2.04%; reduce water consumption by 30% -40%, an area reduced by 1/3, and stroke adjustable, as electromagnetic adjustment motor drag make pumping can be adjusted. Its performance reached the advanced level, it is one of the ideal energy-saving equipment re-election. 4- electromagnetic speed motor section;; 1- dressing groove portion; 2- rubber membrane portion; 3 - tapered bucket portion 5- cam box section; 6: product structure and material: sawtooth jig structure shown in Fig. - supply pipe flange; 7- screen; 8- mine shafts (2) Type sawtooth Jig by supply pipe flange mounting positions divided left and right two. Standing mine shafts end, to the port of discharge, the supply pipe to the left of the left type, and vice versa for the right formula.