Anyang high temperature glass flake epoxy glass flake coating clay

, Salt 1000h not blistering, no loss (composite coating) Finish all surfaces to be coated should be clean, dry, clean (including water vapor, dust, grease, rust, etc), in line with GB8923 standards [ which guidelines Regulatory Requirements: blast Sa2.5 level or mechanical polishing St3 level, 95% cleanliness, surface roughness (40-70) μm, surface treatment, primer before recoating 7041, the steel surface oxidation, It should be re-rust treatment, the required visual standards. Surface temperature should be at least 3 ℃ above the dew point to avoid condensation. ]. Construction before mixing after each coat must be thoroughly stir paint with power, subversion turn 1-2 times a two-component paint bucket must be in proportion certification guidelines will join A group of group B with stirring added to the coating mix should not be resealed Mixing ratio See product certification mark the end of the mixing time in ≥3 h, face ≥8 h applicable standard of presentation, are to double or multiple component materials, component coating is no such requirement if prolonged stoppages Use is recommended to re-start the deployment of the new air spray paint 7043,7044 Recommended - Pressure 0.3 ~ 0.6MPa, spray viscosity 18S ~ 22S / Tu