Varnish V-1630FS

VIKING V-1630FS H class (180 ℃) high temperature insulation varnish hardened color: transparent Viscosity: 25 ℃ 30-75 cps Density: 25 ℃ 0.82 gm / cc solid content: 34-36% Flash Point: 6.7 ℃ Table dry Time: 25 ℃ 15 minutes surface hardening time: 25 ℃ 2-4 hours (For a second layer of glue within 2 hours, 24 hours before the job) completely hardening time: 25 ℃ x24 hours or 25 ℃ x1 hours +80 ℃ x1-2 hours (if vacuum impregnation, curing time will be extended about twice) Thinner: T-6600 Dielectric strength: (dry) 3300 ~ 3400 volt / mil (wet) 2300 ~ 2500 volt / mil adhesive strength: 25 ℃ 24 Lb 100 ℃ 3.3 Lb (according to ASTM D2519 test line to MW35) Shelf life: 25 ℃ year (unopened) Solvent resistance: Good (For FREON Please resistant to dry for 30 minutes or 135 ℃) UV-resistant: good Waterproof: good weldability again: good temperature: 180 ℃ Uses: ﹑ coils, transformers and PCB Packaging: 5 GAL use this varnish of customers can apply for the UL class B insulation system ﹑ grade of F or H factory certification. Drying water-based varnish to form FS-1320 varnish, is a modified alkyd resins, amino resins, additives, organic solvents and other raw materials Second, the characteristics ● resistant grade of F grade three, ● high solid content Good penetration ● Good insulation stability ● strong adhesion, low water absorption ● Good thick layer of dry moisture resistance ● Good mildew resistance ● light color, transparent, non-corrosive paint bright ● higher heat resistance, resistance to yellowing IV: Applications ● electrical materials ● resistors, capacitors, printed circuit boards ● ● Motors, Motor ● Transformer ● various coil winding Fourth, the construction and the matching requirements of FS-1320 varnish can be sprayed, coating, dip, suitable temperature 105-135 ℃, after drying good film adhesion, flexibility, and high hardness. FS-1320 varnish can be used with a variety of varnish FS series supporting the use of thinner, construction can stir after dilution, dilution into the user may be diluted according to their desired viscosity and film thickness. This product is flammable. Evaporation of harmful gases, should be applied in a well-ventilated place, stored at room temperature, avoid direct sunlight, please store in a qualified hazardous goods warehouse. Varnish V-1630FS