Supply polyacrylate emulsion

Supply acrylic emulsion SKNBS acrylate copolymer emulsion / acrylic emulsion (referred acrylic emulsion) A polymer aqueous dispersion, after adding cement mortar polyacrylate emulsion cement (acrylic emulsion mortar). The mortar has excellent adhesion, crack, antifreeze, seepage, corrosion, resistance to chloride ion penetration, abrasion resistance, aging properties, suitable for water conservancy, port construction, highways, bridges, metallurgical, chemical, industrial and civil construction and other seepage, corrosion protection of steel surfaces and repair works and reinforced concrete structures. Acrylic emulsion mortar also resistant chemical acid, urea, benzene and other corrosion, has been included in the national "industrial construction corrosion design specifications" GB50046-95 as chemical corrosion-resistant materials. Compared with conventional epoxy resin mortar, acrylic emulsion mortar also demonstrate its superiority, not only low cost, and ease of construction. Acrylic emulsion mortar ordinary mortar similar construction and can be manually applied, but also mechanical spraying, and wet surface for bonding, non-toxic, and the foundation concrete temperature adaptability, resistance to atmospheric aging, life with ordinary cement mortar, to overcome the ring Oxygen mortar often because expansion coefficient greater than the base concrete cracking disadvantage off. First, the product features high water impermeability effect good bonding strength can be integrally formed with the structure of anti-corrosion ability, acrylic emulsion mortar to acid, alkali, salt and other chemicals, corrosion resistance, high humidity resistance, aging, frost resistance Product water-based, non-toxic, environmental compliance Second, the scope reinforced concrete structures, defense facilities waterproof plugging the dam, seepage port handling hot tub, landfills, chemical storage, chemical tank and other chemical resistance building roads, bridges, tunnels, culverts, concrete repair industry and civil construction roofing, bathroom, basement seepage prevention treatment of steel and reinforced concrete waterproofing Third, the construction method of the base surface treatment: In addition to cutting the old concrete surface eroded layer, water rinse, clean and maintain the basic , solid. Preparation of acrylic emulsion mortar cement: sand: water: acrylic emulsion = 100: 165: 50: 25 to 38. Anticorrosive impermeability high when the amount of acrylic emulsion can be increased to 35 to 40, a corresponding reduction in the amount of water. Brushing the surface of the base layer of acrylic emulsion paste, milk propionate ratio of: cement = 1: 1, stir and paste when uncured acrylic emulsion mortar paving. Paving machinery spraying large area available, cell construction. After construction mortar layer shall conserve seven days. Note acrylic emulsion mortar construction temperature above 5 ℃ with above grade 42.5 ordinary portland cement, sand must 2.5mm sieve over a mixing acrylic emulsion mortar is not too much marinated mortar should be used within 45 minutes four packaging , storage and transportation of the product to plastic drum: 200kg / drum Storage temperature above 0 ℃, valid for 12 months, non-dangerous goods, general cargo transport welcome new and old customers to visit Tel please contact 15026956485 Kim