Xin Li Certified, UV curing tunnel furnace, UV curing tunnel furnace manufacturer

⑶UV maximum lamp life is generally 800-1000 hours after replace reached, because this period intensity UV lamp emitting ultraviolet rays becomes weak, will affect the curing effect. At the same period, according to the manufacturer recommends the use of the environment (dust content of air) is different, at the appropriate time with ethanol to clean the lamp and reflector surface of the reflector plate surface, UV lamp and then turn 90 °. This is conducive to UV rays all effective radiation onto the UV ink or varnish, guarantee a certain penetration. ⒉ reflector type of a focusing reflector, non-focus type and multi-reflection type. Focus type is generally used. Structural characteristics of this reflector is reflected UV light energy concentrated, high-efficiency light-cured, in favor of thick ink curing ink, ink can deep completely cured. In this regard should be noted that the reflector material selection and shape. uv curing machine maintenance and maintenance methods to edit Day 1. Clean surface dust, keeping the body clean. 2. When you start the machine, check the fan motor is functioning properly, abnormal noise, immediately turn off the machine if notification repairman overhaul. 3. Check whether UV lamp after the lights have been lit, if there are not lit, notify maintenance workers repair. 1 month maintenance. Check the vent is blocked, and clean up the dust. 2. Check the lamp current is normal, the line is aging. 3. Check the fan motor is functioning properly, whether the motor speed to meet the job requirements. 4. Come drive chain sprocket refueling. 5. UV lamp light intensity is also to achieve work standards, the lamp is aging. 6. Clean cavity dust. 1 half maintenance. Check wiring and switches are normal. 2. Motor gearbox refueling. 3. Not less than 5 megohms insulation transformer, if not reach, the transformer must be re-dried. 4. Reflectors with a soft rag to clean with alcohol. 5. Shaft, sprockets loose, two sprocket is vertical. 6. Belt tightness is appropriate. 7. For more information contact the exchange with the case marked the king industrial equipment. www.xldtokia.com