Factory direct ignition coil potting HID Ballasts

First, the product uses: two component epoxy potting for automotive HID ballast potting power. Second, product characteristics: 1, the power of HID ballast effectively improve the moisture, shock, insulation, performance. 2, low density, the same comparison the weight of the mainstream market, encapsulants can be more filling 30% cost savings. 3, low viscosity, fast leveling and automatic discharge bulbs, no additional vacuum. Third, the use of methods and precautions: 1, open the A-component plastic buckets, stirring for about two minutes with a blender along the tank wall and bottom of the barrel, so that the component A powder and pigment sedimentation fully dispersed. 2, weighed in proportion to A, B component. Weighing end with electric mixer were mixed and stirred. Stirring speed control turn around in 1000, so that the glue thoroughly mixed and stirred for 3 minutes. If using manual mixing, stirring rod must stir evenly along the tank wall and bottom of the barrel, so that the full mixing, stirring the gel depending on the length of time determined by the amount, the total mixing time at 3 to 5 minutes, no more than five minutes. 3, after mixing, potting, should be used within the operating time. 4. In general, the thickness of 20mm or less potting naturally degassing, without prior degassing. If the potting large thickness, surface and interior may cause pinholes or bubbles, the mixture should be placed in a vacuum container. 5, the higher the ambient temperature, the faster the cure, the shorter the operating time.