Slag duct

Luoyang State-run pipeline slagging Pipe Co., Ltd. specializes in producing ultra-high slag pipelines, using the average molecular weight of up to 2.5 million of the ultra high molecular weight polyethylene hot extrusion forming, nominal diameter 20-900, loose-flange connection, with high wear resistance, it is the preferred mining, metallurgical tailings transport, slag pipeline! Parameters State-run pipeline pipe industry production of slag: Item density average molecular weight Tensile strength Elongation impact strength (unnotched) Brinell hardness kinetic friction coefficient of thermal expansion coefficients of thermal deformation temperature coefficient of absorption of ultrahigh molecular weight polyethylene Tube 0.935 g / cm3 250 万 400 Kg / cm2 350% can undermine 40 D 0.2 Kg / cm2.m / s 85 ℃ 1.5 10-4 / ℃ 8.5 10-cal / cm.s. ℃ 0.01% slagging characteristics pipeline : wear: the same conditions, the volume loss is only one-seventh of the steel pipe, steel pipe wear than 4-7 times the anti-hypertension: slag discharge pipe is suitable for working pressure of 0.2Mpa-6.4Mpa, use of a wide range. Corrosion: high structural stability, corrosion resistance of a variety of chemical media; no electrochemical corrosion, no coating. Self-lubricating without fouling: In many piping material abrasion coefficient of ultra high molecular weight polyethylene pipe a minimum, the same conditions, the pressure loss of steel is only one-tenth of the seventh nylon tube. The inner wall of the pipe slagging smooth, easy to scale, ensuring the passage rate of the medium. Light weight: the density is about one-eighth of slagging pipeline steel, easy handling and installation, engineering and lower total cost, with good economic returns. Health and safety, non-toxic: slagging pipeline nontoxic, no bacteria, no pollution to the environment itself, recyclable. Low temperature: slagging pipeline operating temperature span, -269 ℃ to + 85 ℃ without deformation, are suitable for use. The main application areas slagging pipeline: the metallurgical industry: coke powder, slag, pulp and smelting waste oil transport. Mining industry: slurry pipeline, mine high - voltage supply, gas supply line. Power systems: power plant fly ash emissions, chemical water system, desulphurization system. Coal industry: coal, coal slurry transportation, air mine, ventilation, drainage system, the desulfurization system. Chemical industry: transport acid, alkali, high corrosive media, brine, salt paste, salt chemical salt transport. Oil: crude oil, natural gas gathering, water recharge. Slag discharge pipe, the preferred Luoyang State-Run Industry! Contact us: Technical Phone: 0379-60692520 Fax: 0379-65260950 Luoyang State-Run Industry - slagging slagging conduit pipe production experts Luoyang State-Run Industry specializing in the production of metallurgical slag pipelines, tailings pipelines, slurry pipelines, etc. industrial wear-resistant pipes, have their own independent plant and technical team, since more than ten years, focusing on the development and production of wear-resistant pipes, products widely used in power plants, metallurgy, mining industry, no longer in the praise. In addition, State-run pipe industry has signed with Shanghai Chemical Industry Research Institute experimental base contract, again in the ultra-high pipe series of innovative, new and old customers to purchase. Slagging parameters 0379-60692520 State-run pipeline pipe industry production: Brand: State-Run Pipe Material: UHMWPE pipe diameter: 65 ~ 800 mm pipe thickness: 8 ~ 38 mm Temperature range: -269- + 80 ℃ friction coefficient: 0.15 wear volume: 6 anti-collision strength: 2.0 MPa For fluid: pulp, waste, slag tailings pipeline Features: high wear: friction coefficient is small, the same conditions, wear a steel pipe 4 to 7 times, self-lubricating long life: In many piping materials, UHMWPE pipe roughness was 0.00022mm, the same condition, only one-tenth of steel pressure loss along the way, seventh nylon tube improve transport efficiency by 20% or more. Water hammer: The impact of sediment slurry pressure has a strong capacity to endure. Corrosion: high structural stability, resistance to water erosion, no electrochemical corrosion. It does not require preservative. Not scaling: pipe wall is smooth, you can prevent the media in scaling the wall, productivity is not affected. Light weight: the density is about one-eighth of slagging pipeline steel, easy to handle and install, especially for places difficult to run the hoisting machinery. Easy connection: all pipeline flange connection, eliminating the need for gaskets. Convenient construction. Anti-aging: in the hot sun for 50 years aging, underground can be used more than a century. State-run production of slag pipeline Project: A Long Yu Yongmei Molybdenum tailings pipeline project (3000 m Φ426) Second, Qinghai Xin-lead-zinc Ltd. beneficiation plant, tailings pipeline project (3000 m Φ219) Third, China Gold Group gold mine tailings management project in Heilongjiang wulaga (2000m Φ110) IV NANJIANG five copper coated iron slag pipeline project (3200m Φ159) Fifth, China National Gold Group Gold Mines Ltd. Guizhou Dragon (2000 m Φ219 ) VI, Jiangxi Lithium Technology New Materials Co., beneficiation plant, tailings wear-resistant pipe (2800 m Φ325) Seven Jilin Meihekou mining beneficiation plant, tailings pipe (1800 m Φ219) Eight, China National Gold Group Manzhouli in Inner Mongolia Osan copper slag tailings management project 2000m Φ110 pipeline, preferred Luoyang State-Run Industry! Welcome to inquire! 13525917859