Designed for surface treatment of aluminum baseboard 8 cm high-end champagne brushed MZ803

We should choose what kind of color baseboard? A.? Is based on the color of the floor baseboard color options amount to close to the color of the floor and the floor than the color is slightly darker. Thus the effect appears more beautiful, generous. This method is suitable for most users. Also have a choice of different colors and floor, so sometimes there are unexpected results. B.? Is to choose a color based on the color of the baseboard Door lines. The main feature of this method is that it can make the whole room has the same colors. Color Door line of color and the same or close the door, and the color of the door is the main color of a room. I highly recommend this method. Skirting Installation: aluminum baseboard yin and yang corner fittings and fixtures with a special. 1. Observe the corner and wall is flat ground, uneven sliced ??flat with a shovel and then clean up, bent or baseboard will put something there was not any full-snapping uneven walls, will leave unsightly gaps. 2. After sawing some 15 cm long aluminum baseboard, we will engage the snaps in the slot on the back, leaning against the wall in the hole to take a snap of a cook mark. Before drilling to observe good water and electricity wiring to prevent mistakes. Drilling interval can not be too large, generally about 40cm more appropriate. Drilling on the wall with a special tool, with a plastic child after driving just lay holes. Screw the bayonet mount on the wall. 3. Wall protruding corner called positive angle, recessed corner called negative angle. Yin and Yang Yin and Yang installation angle is the angle at a fixed point position to draw on the wall, and then take the hole, nailing plastic child, yin and yang corner then fixed with screws in the corner. Note: Due to the buried pipe hydropower project on the wall, switch socket just below is the location of the pipeline, considered a good position when the punch to avoid damage. 4. Finally, the distance with a tape measure to measure out the size of each segment, with the cutter cut out the appropriate size, the card in the appropriate card buckle. Aluminum baseboard each length of three meters, in length beyond the wall to install a baseboard snaps in the middle of the interface, so as to ensure smooth baseboard. Skirting the wall to completely close, leaving a gap, it is more beautiful, especially the corner. It should be tested before installation flatness of the wall.