51 wave rise Deck

yx51-226-678 yx51-226-678 floor boards floor boards is a more traditional form factor, is also relatively less on the market, mainly due to some of the new plate came out, 678 floor boards into material width of 1000mm, the use of a relatively small area, has gradually been replaced by other plate, I 51mm wave boards in addition to 678 high-rise buildings, mainly in yx51-305-915 and yx51-342-1025 floor boards mainly, 1025 type floor boards not only large but also the cost and use of floor boards compared yx51-226-678 also a lot cheaper. More knowledge about the floor boards please pay attention to my site http://www.hnzhongchuang.com. Also welcome customers to visit our company an opening ceremony outside the floor boards floor boards Our other models are mainly: YX76-305-915, YX51-305-915, YX51-342-1025, YX51-240-720, YX50 -180-720, YX51-253-760, YX76-344-688, YX51-250-750, YX35-125-750, YX75-200-600, YX75-280-840, YX75-230-690, YX75-293 -880 yx51-305-915 floor boards and other models for a better understanding of yx51-305-915 floor boards, I am here to choose a model and 915 for floor boards floor boards for comparison. Take yx51-240-720 floor boards compared to it. Purpose: yx51-305-915 and yx51-240-720 are the same, are used as permanent formwork use, but also about the same load capacity. Cost: thickness of 1.0mm, material Q235,915 floor boards is 55.7 / m * 2,720 floor boards is 57.8 / m * 2, first floor boards 915 cheaper than the 720 for some;-use area: yx51- 305-915 floor boards use area is 0.915 / m * 2, yx51-240-720 use area is 0.72 / m * 2, compared to the look of some 915 more. Production speed: yx51-305-915 production process requires points, which resulted in the refueling process is very cumbersome, and you do not need yx51-240-720 points, compared to 720 for the floor board production speed faster. These are the 915 and 720 for floor boards floor boards in price, the use of the area, some rather more on the production rate of knowledge about the floor boards please pay attention to my site http://www.hnzhongchuang.com. Also welcome customers to visit our company