XW- aluminum ceiling wall panel ceiling installation diagram

Ceiling Installation Instructions 1, according to the same level of height installed aluminum repair the corners 2, according to the appropriate well spacing lifting boom and metal frame, hanger spacing of less than or equal to 1.2 meters, light steel keel spacing is 1.2 m 3, the pre-installed on the triangular keel triangular keel hanging pieces together with metal frame into vertical press plate spacing is connected, and then adjust the level 4, the two sides parallel side plate is pressed into triangular keel cracks, transverse direction after the first load Pull the two ends of a straight line while looking after a row at right angles to gradually withhold plate, to be adjusted once after every breasted ensure board formation, vertical seams. (Note that a square plate with a side bet pits direction is inserted triangular keel seam) 5, to wear gloves when pinch, if they leave dirt on the plate printed with fresh water wash, forbid torn installation Ceiling protective film 6. Purchase and accompanying keel, accessories shall conform to product quality requirements, without bending. 7. In the transport and stacking process, aluminum ceiling shelving smooth, not under pressure, and to avoid the erosion of the high temperature and harmful substances. 8. flat keel installation spacing deviation should be controlled within the allowable range of 1.5 meters. 9. When the installation of aluminum ceilings, such as the size of a rear bias adjustment should be thoroughly sequentially inserted inlay can not hard plug to prevent deformation. 10. A large lamps, exhaust fans and other things should be done alone keel fixed, should not rest directly on the aluminum ceiling.