Why cork tiles ideal for geothermal heating

Currently on the market known as geothermal energy for heating of the floor a lot are: tiles, wood flooring, wood flooring, laminate flooring, even bamboo flooring, PVC floor, but what kind of flooring most suitable floor heating use? Cork tiles proven superior performance is more suitable for the geothermal heating. ? High temperature deformation strong stability: ??? geothermal heating source temperature is generally the maximum temperature around 60 degrees, the temperature changes from 0-60 degrees for stability of the floor will be a very high demand, the floor to be able to effectively break release floor stress under high temperature generated. Cork tiles unique honeycomb structure makes it more than solid wood flooring fibrous structure in the case of extreme changes in temperature or humidity, which can withstand changes in temperature from minus 60 ℃ to 80 ℃ above zero, the more effective the release of internal stress, ensure that the floor does not crack, not cocked, greater stability, and for a long time at high temperatures and will not appear faded, rough phenomenon of light. ? Heat faster: ??? on heat conduction, the use of ceramic tile floors with wood than heat, high thermal efficiency. Tiles not as swollen, bent phenomenon will appear like wood floors. But something else cold tile heater, the insulation effect was not as good wood floors, large heat loss, it will cause too much energy. The general floor after the installation is complete, the total thickness of the laminate flooring as the 10-14mm, parquet to around 15-20mm, and cork tiles thickness of only 4mm, not only conductivity fast and unique honeycomb structure has good thermal insulation effect, heating up fast cooling slowly, but can save energy. ? Low formaldehyde emission: ??? general floor environment at room temperature may not be exceeded. But in the geothermal environment, the higher the temperature, the higher the formaldehyde emission. To warm the surface temperature is about 30 ℃, when formaldehyde emission at 20 ℃ which is about 10 times the 15 ℃, then in the case of 30 ℃ will be a great value. In a relatively closed room, plus an indoor formaldehyde caused by the release of other items, indoor formaldehyde may be exceeded, will cause harm to humans. So from this point of view, not all are suitable for use on wood floor geothermal heating. Cork tiles low formaldehyde emission, detection of formaldehyde emissions is only 0.3mg / L at 45 ℃ high temperature within the E0 level 0.5mg / L environmental standards, equivalent to only we eat an apple formaldehyde content is almost negligible . ? Waterproof fear wet conditions: ??? the floor for ground heating requirements in small dimensional change under high humidity, moisture better performance, lower its moisture content and thickness swelling, the less likely swelling. The cork tiles of water was only about 5%, and itself has a natural water impermeability, waterproof, do not set aside time to install retractable gap rigorous pavement wet environment can bathroom and kitchen. ? Comfortable and beautiful: ??? geothermal heating in line with "warm feet and cool roof" of human physiology, the room temperature gradually decreasing from the bottom up, giving the foot of the thermal head cool comfort, and the use of cork tiles are more flexible , bare feet are not cold, not slippery, not hard, foot feeling more comfortable and natural. Pole is without heating season (winter, spring or fall approaching and did not open when the winter heating), it can also barefoot is not cool, non-slip, not a hard step on it, the comfort is tile and other wood the floor can not be done. ? Experiments and practical use shows that: ??? cork tiles are not deformed at high temperature, thermal conductivity and thermal resistance, formaldehyde environmental protection, waterproof, comfortable and beautiful aspects of ceramic tile, wood compared to a more excellent performance, very suitable for geothermal heating , geothermal heating perfect configuration!