Stand-alone dust collector

Works from the air inlet into the dusty gas through the hopper, the gas in part of the large dust particles by inertia force and gravity are separated, directly into the bottom of the hopper, hopper dust and gas after entering in the box bag zone, the gas passes through the filter bag, the dust is retained on the outer surface of the bag, the purified gas through the mouth into the bag after the box, and then discharged from the outlet. With the extension of filtration time, the dust layer on the continuous plot thick bag, rising resistance to dust removal equipment, when the device resistance rises to the set value, the cleaning device start cleaning. First, a sub-chamber poppet valve is closed, the gas cut-off filter, then electromagnetic pulse valve is open, compressed air in a very short time the rapid expansion in the housing, into the bag, so that bag expansion and deformation vibration, and erosion in the reverse flow Under the action, attached to the outer surface of the dust bag is stripped fall into the ash bucket. After the cleaning is completed, the electromagnetic pulse valve is closed, the poppet valve is opened, the chamber resumed filter status. Cleaning each room in turn, begin to start the next cleaning a cleaning cycle from the first chamber cleaning. After filtration and cleaning work are trapped dust falls down the hopper, and then discharged from the hopper mouth concentrated. When installing the start, our company engineer to the scene to guide the installation works until completion, after test qualified, the demand side will provide a commissioning report back to our company engineer the record, archive.