Supply heater thermostat heating thermostat wall warm blanket thermostat factory direct!

☆ technical parameters Operating voltage: 220VAC, 50HZ ☆ controllable power: ≤2000W ☆ leakage current: ≤10mA ☆ leakage action time: ≤100mS ☆ temperature control range: 0 ℃ -99 ℃ ☆ temperature regulation accuracy: ± 2 ℃ ☆ work Temperature: -30 ℃ ~ 50 ℃ main function 1, the power of digital full-display 0.5S, then displays the current actual temperature. 2, the automatic mode: the room temperature below the set temperature, the heater works automatically; reach the set temperature, the heater stops working. 3. Timing Mode: set time the heater operates automatically until it is manually closed. 4, the manual mode: Keep pressing on the remote "switch" key to open or close the heater. 5, digital bottom right "." Liang said automatic mode open; digital intermediate "·" light indicates the timing mode is turned on; two light while light indicates automatic mode and timing mode simultaneously open, regular time not yet reached the automatic mode is active, regular time the timing mode is active, while the lower right corner of the digital tube "·" Off; two lights at the same time showing off the manual mode is turned on. Use 1, the thermostat connected to the power, the digital display of the current room temperature. 2, the heated state heat indicator light; unheated status indicator automatically turns off. 3, according to the panel or the remote control "temperature / △" button, the digital tube "20" is blinking, "Temperature / △" or "Time / ▽" button and then the panel or the remote control, "the set temperature" rise or fall 2 ℃, set the temperature range of 6 ℃ -36 ℃. 4, according to the panel or the remote control "Timer / ▽" key, digital tube "00" is blinking, "Temperature / △" or "Time / ▽" button and then the panel or the remote control, timing up or down 1 hour , regular time in the range of 00-24. When the timing is set to "24" does not start timing, saying that he starts every day at this time when the timing is set to "00", it means the time when the timer is set to "03" and three hours later the same day, start time start up. Other analogy. After the heating time start can press on the remote control "switch" to turn off the heater. 5. Press on the remote control "automatic / manual" button, switch "Auto / Manual" modes, in the "manual mode" just in time on the remote control "switch" key to activate or deactivate the heater. 6, in a heated state, if any leakage, the digital display "LD", until the fault is removed reboot. Notes Select mounting location Note: Do not place the heater directly heating the region, in order to avoid too frequent opening and closing the thermostat.