Car battery cable clamps emergency ride FireWire battery, power cord

Name] car battery emergency power line 500A line [Material] Chuck [form] thick metal wire positive and negative two - Size 12mm thick wire cable length 200cm [Weight] 1.42KG follows [connect] (1) First, Red wire clamp start line above the red battery cathode; "; rescued car." Red wire clamp (2) and the other end on top of the red battery cathode; "; rescue vehicle." (3) the black wire clamp "; rescued car"; the black negative battery. (4) Then the black wire clamp "; rescue vehicle"; the black negative battery. (5) Start "; rescue vehicle"; the engine, and then start "; rescued car"; the engine. If you find rescued car still does not start, check the metal contact portion is bad. After completion of starting the engine, still take the line of fire in order to start to remove, or they may cause a short circuit. [Demolition line procedures are as follows - (1) First, the "; rescued car"; black wire lowered. (2) then "; rescue vehicle"; the black wire removed. (3) Then "; rescue vehicle"; the red wire lowered. (4) Finally, the "; rescued car"; the red wire lowered. [Note] 1. strict accordance with the operating steps. 2. Check the label two battery voltage, ensure that the same voltage of the two batteries. 3. Turn off all vehicle load, hanging neutral position, pull the brake to get started, start the engine. Smoking is prohibited in the vicinity of the vehicle. 4. If the car battery is frozen, prohibiting launch, or it may cause an explosion. 5. Make sure the battery cable polarity is correct. 6. When operating, the car can not be in contact with other vehicles. 7. The battery produces explosive gases! Wear protective goggles when installing the cable. 8. If the battery acidic substances inadvertently leaked, spilled into the skin or eyes, immediately flush with water and consult a doctor.