C37 shell kit

Custom processing: Model: YT --- DR --- C37E14 Dimensions: 98 * 37 (mm) color: white (optional) Type: candle lamp types: plastic clad thickness: 1.5 (mm) Material: thermal plastic, aluminum brand: Astra optical main scope: E14, C37 plastic clad aluminum components: As the plastic and aluminum have their own shortcomings estimate, aluminum fast heat conduction, but also thermally conductive plastic insulation, heat dissipation comparison Good, but worse thermal conductivity than metal. Plastic Clad combine the two to make up for lack of advantage, the outer layer with high thermal plastic inner layer using aluminum, made out of Cooling Kit performance. Plastic clad aluminum structure thermal performance, price, safety and design, and so has many incomparable advantages, mainly in the following four major advantages: First, lower environmental costs, totally pollution-free. After the end of life, can hundred percent recycled, and secondary processing is relatively simple and requires only molding can be broken again, unlike the scrap that reprocessing will waste a lot of electricity and water. Second, good heat dissipation. In the cooling mode Cooling Kit is generally aluminum passive cooling, the temperature difference with the surrounding environment to achieve cooling; plastic clad structure is active cooling, higher efficiency, internal through aluminum to thermal conductivity, high heat plastic external cooling. The plastic contains some special organic material, the main reaction by melt blending surface obtained. Ordered by grafting optimization and materials on the basis of a certain degree, this nitride composite material sufficient to construct a network structure, a certain ordered microchannel carbon tubes, and heat resistance become the main channel absorbing external air and internal heat exchange, convective and radiative heat forming, thermal conductivity of 5.5W / MK. Third, high safety performance, although better than the thermal conductivity of metal plastic, but its conductivity good, so there is some risk of leakage, it is difficult to pass safety certification. The heat insulating plastic is optimal, after the heat-resistant plastic may be specially treated high pressure 5,000 volts. It also has a strong cold temperature properties can be used at temperatures of -40 ° to 130 ° without cracking and deformation. Since the conductive aluminum heat kit reason, usually with isolated power, not only will increase the weight of the lamp, and potentially also increase the cost of the lamp. The use of plastic clad structure you can use non-isolated power supply, or even a linear IC driven from power in the can save a lot of costs. Fourth, the plastic is easy to process, more beautiful and stylish design. The traditional LED aluminum heat housing due to process constraints, generally only made a handful of styles, while the conventional plastic molding difficult due to poor mobility characteristics of products made out of rough appearance, the appearance of a single simple structure