Light diffusing silicone encapsulants

Description: JTF-1018 has a high diffusivity, good high-strength, translucent, medium elasticity, insulation and thermal conductivity, anti-flex, a variety of excellent anti-oxidant properties, water resistance, high temperature and so on. Products and silicone tank, PVC tank, plexiglass, aluminum ducts close bond. This type of product is characterized by small shrinkage, curing process does not produce stress, is mainly aimed at existing packaging materials (epoxy, PU glue, PU modified epoxy, etc.) is easy to yellowing, poor heat dissipation, no light diffusion, etc. and the development of a fatal flaw for the sections of the LED light bar and piranhas, the Great Wall of lights and other LED lighting lamps of special potting. Usage: 1. with plastic, this series are two-component liquid glue, the use of two components need to be in accordance with 10: 1 ratio, and stir with a stirring device (be sure that the two components mixed). Note: do not stir bar and containers and other plastic contact! 2. evacuation, since small silicone molecules tension, so when the vacuum inside the bubbles easily accumulate, you can see a lot of bubbles very fierce discharged. Therefore, in order to avoid waste of glue, try to repeatedly put gas release valve at during evacuation; 3. remove air bubbles can be transferred into a professional potting glue drip irrigation equipment. 4. Epoxy finished, place about 4 hours, until the surface tack (completely dry after table) to be packaged. The main technical parameters: 1. Dry time: 4 hours; 2. initial cure: 8 hours 3. Fully cured: 24 hours 4. transmittance:> 80% 5. refractive index:> 1.50; 6. Hardness: 33 -35A Features: 1. High strength, high toughness; translucent, light transmittance higher than 80%; 2. Good heat resistance, high temperature (long-term use at -40 ℃ ~ 220 ℃), good; 3. Non-white, the product six months soaked experiment unchanged; 4. Long life, the product life of 10 years, maintenance-free; 5. Anti-oxidation, non-yellowing, product and chemical properties and physically stable; 6. UV resistant to prevent leakage or ultraviolet UV shielding; 7. Room temperature curing operation, to solve the technical bottlenecks in the industry; 8. Excellent stress relief capacity. Note: 1.U catheter irrigation was full of some of the possible, more beautiful after curing. 2 curing agent can make some adjustments with the room height. 3 silicone catheter preferably pretreated before gluing, surface curing will be better. 4 clean holding container use and can not be mixed with other encapsulants, curing agents and avoid the contact with fire alone sealed, two-component mixing Please run in dry time.