Supply 3 light-emitting waterproof module 3528

A technical parameters Product Description: Three lamp 3528 waterproof module Operating voltage: DC12V Dimension: 75MM * 12MM Color: white / red / warm white / yellow / blue / green wire length: 100MM gray line Packing: 160PCS / Cascade package: 30 Group / serial LED type: 3528 power: 0.24W Brightness: 1400-1600MCD 2 Product Features 1, power: low operating cost, energy saving than traditional light sources over 80%, and repeat Use 2, long life: difficult to damage, good repair, maintenance costs low. 3, high brightness, rich colors: the direct conversion of electrical energy into light energy, the axial brightness is ten times of traditional light sources, is a solid cold light source. 4. Safety: Ultra safe 12VDC circuit design, completely eliminate the risk of electric shock, the use of ultra-secure. 5, easy to use: common and standard wiring and easy fixation products, easy to learn, general electrician can quickly grasp. In the various installation environments, can rapid construction. III. Product Installation 1.LED presence of positive and negative points, pay attention to the power port wiring must be installed positive and negative, respectively. 2. Installation requires the use of double-sided adhesive or wood glue, the module slot and the plastic base plate firmly paste. When using double-sided adhesive, it is necessary to fight together with glass, plastic, or prolonged exposure to outdoor sunlight under, can cause modules off. Remember! 3. Using low voltage input, so absolutely do not undergo power and direct access to 220V, otherwise it will create a whole module burned. Remember! Number 4. The power outlet module serial port group, not to exceed 50 group, otherwise the end of the module because of voltage attenuation, resulting in decrease in brightness. Although the formation of the loop to avoid the occurrence of decay, but should not have too many modules. 5. The water treatment has not been installed in the font or cabinet, should prevent rainwater from entering the font or box. 6. The module space requirements can be adjusted according to the brightness of each square distribution is best controlled at 50 to 100 groups. 7. When the installation can not be pushed, squeezed, the pressure on the module device, so as not to damage the device, affect the overall results