Kunshan proof emergency lights

Kunshan proof emergency lights please call center in Kunshan, Jiangsu convinced explosion-proof electrical explosion-proof emergency light use: 1, the installation: first the actual needs of the job site to determine where and how the lighting installation, and then from the power contacts to prepare the appropriate length of Φ10 luminaire - Φ14 mm three-core cable. 2, wiring: Loosen the M6 ??socket screws inside the cover, open the rear cover, unscrew the lamp cable into the mouth of the compression nut, remove the sealing sheet, the power cable through the compression nut introduced into the terminals inside the lamp at fixing the cable, then tighten the cable gland nut, front cover and then lighting installed. 3, replacement of light: When replacing the LED and circuit boards, before opening the lamp cover, turn down the front cover, first remove the reflector cup, LED components and circuit boards and then removed and replaced with new LED components and circuit boards, mounted on the front cover to the lamp. Explosion-proof emergency light Note: 1, when the lamps installed in the carriage is equipped with cardboard boxes, and add the foam cushioning. 2, the installation of lamps, luminaires should be safe ground nearby. 3, when used, has some light surface temperature is a normal phenomenon; Transparency center temperature is higher, not touch. 4, maintenance of lamps, you must first disconnect the power. Explosion-proof emergency light Safety Warning: 1, must be cut off the power before replacing the light source and remove lamps; 2, non-charged open lamps. 3, should view the line or change the light source to bring clean white gloves. 4, non-professionals are not free to install, remove lamps and ballasts.