Shanghai ZSZM-SOLED solar LED Solar Square spike spike production order

Solar energy spike - on both sides of three lights, two lights on both sides of solar spike variety of materials can be customized on both sides of three lights, two lights on both sides. Solar spike - red, yellow, white, blue, green solar spike a variety of colors, red, yellow, white, blue and green colors can choose any combination. Is a spike, set along the roads, the weather for the next night or fog, indicating the direction of the road ahead, the retroreflective material, housing, solar panels, LED, control devices, has a self-luminous and passive reflective properties Visual induce facilities, usually in combination with standard wire. Technical parameters of solar spike: 1. Size: 103 * 105 * 22mm 2. emitting element: LED luminous intensity: single LED lamp is greater than 6000mcd Power supply: solar cells (monocrystalline silicon) 0.3W 2V / 80mA energy storage device: rechargeable battery 1.2V / 650mAh NI-MH high temperature battery 3. Working Time: positive standard light intensity, time according to the sun eight hours of continuous support 72 hours Display: Flashing (2Hz ± 20%) color-color: red, yellow , white, blue, green 4. Working environment: -20 ℃ ~ + 75 ℃ Kai control light intensity: less than positive light 500Lux 5. compression capability: static compression of up to 100KN. 6. Protection: IP67 solar spike characteristics: 1) high brightness LED light source, double-sided light, luminous uniform, soft light, no glare and good stability. (2) LED active light reflective lattice with efficient automatic reflex, is more effective. (3) warning of strong, visible distance up to 500 meters or more. (4) fine shape The body is cast aluminum. (5) Installation is simple, safe and practical, low failure rate. Solar spike of performance indicators: 1) compression performance. Solar spike bare, exposed solar panels using PC bulletproof material to enhance compressive strength of electronic parts, reducing the use of IC control electronics reduce pressure on the electronic part, on the housing design of stiffeners to share part of the pressure. 2) sealing performance. Separation design, LED lampshade and internal circuit board with isolation design. Use strong neutral bonding plate materials to ensure the solar panel, LED lampshade and spike shell close connection. 3) brightness. Luminous intensity, to the Ministry of Transportation Index 2000 MCD. 4) stability. Battery NiMH batteries do not meet the state requirements, electronic circuits follow simple and effective design principles, welding firm, solar panels with high hardness, wear resistant circuit board. Improve the conversion efficiency of the solar panels. 5) batteries matching. 6) environmental adaptability. Regional special circumstances can make the appropriate adjustments. 7) is a spike, set along the roads, the weather for the next night or in fog, indicating the direction of the road ahead, the retroreflective material, housing, solar panels, LED, control devices, has a self-luminous and passive reflective properties of visual induced facility, usually in combination with standard wire. Solar spike installation process: 2 Location: determine the installation location, the installation at to smooth, dry, clean and seamless. 2 with glue: glue stirring uniform, consistent color. 2 glue: glue moderate, both cement and do not spill too much ground spike. The glue on the bottom surface of the signs. 2 Tour: After two hours of installed spike check again. 2 Cast aluminum with foot spike, nail feet deeper than the depth of the space, hole diameter greater than the diameter of the nail feet.