Zhucheng Kun-hsin machinery has been certified, Jilin scraper, scraping mud machine works

Installation and operation requirements of the rack on a plane must be leveled, Tolerance 0.50 ‰, gearhead output shaft and the vertical axis associated with jaw connection, the coupling with three pin holes, each hole has a shear pin safety pin, as had torque moment off to protect the whole machine use. Scraper rake the bottom margin bottom holding 50mm tolerance ± 100mm. The lower end of the vertical axis in the mud over the bucket, put plain bearings, nylon bushings, national water use pressure lubrication. You must set dg15 lubrication pipes, lead from the outside to the pool bottom, buried in the bottom, the outside surface of the water can not be higher than the bottom surface, stretched out on the outside of mud fight, slide bearing fittings and turned. Often the introduction of water pressure to ensure good lubrication, it can test run. In normal operation, you must before driving, turned the pressure of water, keeping good underwater bearing lubrication. Vertical shaft end radial bearings and thrust bearing assembly only, with grease lubrication, good lubrication requirements. When commissioning, the machine empty load operation less than two hours, for a smooth operation, noise below 80db. Test run with a load of not less than 24 hours. First, the sludge use for urban sewage treatment plants and waterworks advection sedimentation tank, according to user requirements, additional rake, skimming devices. Second, the main features of (1) bilateral drive, synchronous transmission on both sides of the wheel, smooth (2) Water traffic using steel wheel walk, walk underwater roller blade rubber (3) skimmers and scrapers reverse operation (4) easy to operate, can be directly on the spot, the operation of the remote control device