Rotary ring gear pinion Where to buy how to price

Rotary gear for installation, find the right course of a few notes: (1) gear for installation in a rotary kiln, looking straight ahead, the cylinder must be adjusted to the centerline of the spring plate riveted to the correct location. (2) in a rotary kiln gear for the installation and alignment process, preloaded ring is a very critical part, when the pre-need high-quality, high standards and strict requirements, the ring and the cylinder during installation alignment only "pair", can not be corrected on the ring gear. For pre-installed ring gear must be integral lifting, or ring counterparts at the pin and bolt difficult to install, fastening, but can not guarantee the interface ring gear pitch error and roundness tolerances.  (4) of the spring plate and cylinder must fit closely in the free state can not force the spring plate and cylinder fixed, riveting, otherwise, after loosening screw top and drawing, under the action of the spring plate of rotary kiln radial and face runout ring will increase or error exceeded.  (5) radial and face fine alignment jitter values ??must be less than the standard values. After the removal of jackscrews and brushed, rotary kiln ring gear radial and face runout may increase, but the difference will not be exceeded. When  (6) of the spring plate and cylinder with drilling, according to the sequence diagram, each one with a hole is drilled fastening bolts. (7) rotary kiln overhaul deliver production runs 12h ~ 24h, to stop the kiln to check the spring plate rivet situation, and their counterparts in Rotary screw secondary ring gear solid.