Stand-alone dust collector pulse

 Single dust collector works: dust and gas from the inlet into the box from the bag filter dust is retained on the outer surface of the bag, the purified gas is discharged by the fan through the outlet outside the box, directly into the Indoor. With a host of continuous work, outside the bag dust adhesion increase, thus increasing resistance of the device, this must be regular cleaning, so sticking out of the bag and shake off the dust down, after falling to a dust collector hopper in the manual removal, will extend the life of use. The main cause of dust ejectors include two things: 1 Install filter is not powered. When installing the cement silo top dust, there is no power. Resulting cement warehouse roof ESP, unable to work after each will be attached to the outside of the filter dust cleared away. Cause stirred tank pressure, if not installed pressure relief valve. Is likely to occur, the risk of cement warehouse roof ESP warehouse explosion. Therefore, the pressure increases, the pressure relief valve over cement silo cordon, which automatically deflated, drive along dirt flying tank. Low 2 safety awareness. Workers at the time of production, often forget to turn on the vibration motor. Precipitator dust can not be properly cleaned cause excessive pressure inside the warehouse, causing dust explosion or pressure relief valve ejectors.