CJF autoclave

 CJF autoclave is magnetic drive device is applied to the reaction apparatus typical innovation that solved the problem of leaking before packing, mechanical seal can not be overcome fundamentally, no leakage and pollution, is the current high temperature, high pressure The most ideal means of chemical reactions, in particular, be flammable, explosive, chemical reactions du medium, more shows its superiority. After washing the autoclave CJF claim 1, the reaction solvent from the exhaust valve of the autoclave is filled, most of the residue was washed, poured into water kettle were stirred for 10 minutes and a half, this time before opening the autoclave lid, inner wall of the vessel cleaning. 2, cleaning, must be cleaned kettle lid, sampling valve, while lower in the case of the kettle with water, a little recharged with nitrogen. 3, temporarily unused reactor, the reaction is preferably added to the kettle 70% by volume of anhydrous chun soak a clean, you can not tighten the screws. After cleaning the autoclave before the next use convenience. CJF autoclave Note: .CJF autoclave at designated sites to use, and to follow these instructions. Identify the body of the container cut in the test pressure on the pressure and the maximum operating temperature and other conditions, to be used within the conditions of its permit. The autoclave is a precision instrument through the seal ring with the purpose of sealing cone contact form, by tightening the main bolt pressed against each other and reach make them sealed. Special care must be sealing cone, avoid all kinds of collisions and damage it. When loading the cover, first place the good reactor vessel body, then the lid was fixed position, carefully mounted on the tank body when tightening the main bolt, you must press on the corner, symmetrically in multiple progressively tightened, the force should be even allowed kettle lid tilted to one side, in order to achieve a good seal, the tightening torque to prevent the sealing surface squeezed bad or accelerated wear can not exceed the specified. Pressure gauge is used, its pressure is preferably marked within 1/2 of use. And often pressure gauge and standard gauge compares corrected. Oxygen pressure gauge used to avoid other gas gauge mix. Safety valves and other safety devices to be used to meet the requirements through periodic inspection instruments. Care must be taken when operating, to be accurate thermometer into the reaction solution. .CJF Autoclave liner inside and parts to keep clean. When the disc cover flange cover, to bolt located on the diagonal, followed by a pair of equally tightened. When measuring instruments rupture, fragmentation in most cases on both sides of the front and rear glass surfaces. Therefore, do not stand in the place where the risk of these operations. Is expected to appear in danger, we should remove the glass, put on a new one. CJF autoclave Wholesale Price consulting invited http://www.huateyq.com/huateyiqi-ParentList-955014/ CJF autoclave Store more product information all in http://www.chem17.com/st280755