0532000004 Busch vacuum filter

0532000004 Busch vacuum pump oil mist separator filter introduction, also known as the exhaust filter is a built-in vacuum pump oil and gas separation apparatus may well be pumping gas and pump oil separation, so that the vacuum pump exhaust pollution gas, meet environmental effect, in some it may be a vacuum pump with a vacuum pump to reach eliminate noise function, because of its simple structure, reasonable cost, so by many pump manufacturers blitz. 0532000004 Busch vacuum pump oil mist separator filter structure typically have paper, metal mesh filter composed of surface and both ends of the plastic cover. Its core component is inside the filter, in the case of relatively good filter paper produced in Germany, with strong separation ability. 0532000004 Busch vacuum pump oil mist filter works in the role of driving force separator located in the side of the fuel-air mixture through the vacuum pump oil mist separator filter paper and cotton. Oil were trapped in order to achieve the process of separation and vacuum gas oil. It is filtered out of the vacuum pump oil return pipe for recycling with the discharge of the oil-free exhaust, to achieve pollution-free, clean effect. 0532000004 Busch vacuum filter a routine maintenance check pump runtime: Use the vacuum gauge to detect oil mist separator is blocked, when the gauge is located in the red area, indicating that the oil mist separator clogged and must be replaced. If there is no oil mist separator pressure gauge, the oil mist separator resistance changes by the drive motor current is measured, excessive consumption of the drive motor current or pump flow rate decreased, indicating that the oil mist separator clogged and must be replaced. b. If the pressure gauge indicates the vacuum pump oil mist separator is usually lower than, or the drive motor current consumption is typically less than, because there is an oil mist separator is damaged, you need to replace the oil mist separator. c. If the gases contain oil, because the oil mist separator is dirty or damaged, replace. Vacuum pump oil mist separator can not be thoroughly cleaned and must be replaced clogged oil mist separator. Replace vacuum pump oil mist separator off before the vacuum pump and disconnect the power supply to ensure that the vacuum pump has been through atmospheric pressure, open vent cover from the tank, by means of a dedicated six with a wrench to remove the exhaust filter, it will be equipped with new seals the open end of the oil mist separator is installed in the tank the correct position